Search results

  1. L

    cabin door

    I am in the process of purchasing a 2009 Searay 310DA. The cabin door doesnt roll very well. Can anyone give me advice on how to replace the rollers or wheels on the unit. I couldnt find any think on u-tube.
  2. L

    fresh water flush port start up

    Volvo 320-CE-B. The raw water cooled engine was marina winterized with antifreeze. Is it safe to start it up if connect a hose to the fresh water flush port(blue plug). I want to run it for a short time before it goes in for survey and sea trial.
  3. L

    F.w.c.

    Are the exhaust manifolds on the new F.W.C. V.P. cat. engines raw water cooled.
  4. L

    8.2 fresh water cooling

    Can someone direct me to a cooling water diagram for the 8.0 cat engine. I'm trying to figure out if Mercruiser's newer unit is a full or half system.
  5. L

    gimble bearing

    I have a DPS-B 1.95 drive and am having trouble finding the proper replacement gimble bearing in the iBoats web sight under shop. Any help would be appreciated.
  6. L

    Idle question

    I have a 2015 320-CE-B (A368343) with a DPS-B. When I shift from neutral to either forward or reverse I get a loud thump. It has been like this from day one. I checked the idle speed with my Tech Mate and it is 700. The workshop manual says that the 5.7 GXI should be 600. The manual does not...
  7. L

    neutra-salt

    I have a Four Winns with the Neutra salt system .Does anyone know if there is any differance between Neutra salt and Salt-Away.
  8. L

    bellows DPS-B

    I would like to change the bellows on my 2015 DPS-B (#A378340). I did an internet search and came up with nothing as far as the procedure goes. Maby because its a recient drive? The V.P. Workshop manual gives the gimbal ring removal, pivot housing removal and explains the positioning and...
  9. L

    Manifolds and elbows

    I have a 2015 Four Winns powered with a 320-CE-B r.w.c. with catalitic converters. The boat has four seasons and 100 hours run in brackish water. Neutra salt was added last season. On previous boats with the 5.7 r.w.c. I always changed out the manifolds and elbows after five years. The cats were...
  10. L

    power source

    I have a 2015 275V and will be installing a neutra salt system. The instruction booklet tells me to power it with a power source that is only hot with the engine running. I have a tester but am looking for any input that could save me from taking anything apart that I don't have to. Thanks in...
  11. L

    impeller lube

    just received a new sea water pump impeller for my 320-ce-b part #22307636. They no longer give a lube tube with it. What is the best lube to use at installation in the spring.
  12. L

    Outdrive paint

    I have a DPS-B drive. What is the recommended paint to use on it. The drive is four years old and clean. The reason I'm asking is that the marina charges $100.00 to paint it after reinstalling it at the begining of the season. Seems a bit stiff. I have to have them do the hull due to E.P.A. regs.
  13. L

    engine alignment

    I have a volvo-320 with DPS-B. Is there any specific type and where can I purchase the proper alignment tool. My marina pulls, services and re-installs the drive annually and I want to keep an eye on things.
  14. L

    trim cylinders

    I have a larson 260 powered by a 5.7 gxi. Drive is DP-SM 1.95. Last season I noticed that I had problems with the trim staying up under way. After season haul out I noticed that the port cylinder is leaking arounf the shaft. I asked the marina to replace it at spring service. Should I just...
  15. L

    Power trim not holding

    I have a 2006 Larson 260 with a 5.7 GXI-G with a DP-SM 1.95 drive. After getting on plane at a comfortable 3400 r.p.m. I usually set the trim. In less than one minute the set will drop off to nothing. Last year I had the pump assembly replaced by a Volvo dealer. The new pump did not help the...
Top