Search results

  1. Ben Clegg

    Evinrude 115 1998 fuel tank options

    Hi I have a 115 SPL on a 17 foot Fletcher , currently I am running fuel from 3 X 25 Ltr (6.6 Gallons) tanks that are linked together so switching over is simply a manual valve operation. I don't currently have a fuel gauge so never know when the fuel will run out until it actually stalls because...
  2. Ben Clegg

    1998 evinrude 115 spl e 115 ts l ec m cylinder id

    Hi guys I think I'm confusing myself with the manual...............(it's not hard to do :facepalm:) can someone confirm deny the below picture is correct? Cheers
  3. Ben Clegg

    WOT Timing Procedure Evinrude V4 115 SPL 1998

    As per Joe's post HERE I don't fancy setting the timing at sea and WOT so thought I would try it Joe's way. I have a couple of questions, can someone help me out please? How do I identify if my engine has the FAST START FEATURE, I'm assuming it hasn't but as I dont know what to look for i'm...
  4. Ben Clegg

    Spark tester

    Hi Can anyone advise me how to make a spark tester, Thanks Ben
  5. Ben Clegg

    Evinrude 1998 115 SPL trim gauge wiring diagram

    Hi can anyone tell me how the trim gauge is wired on my 115 1998 Evinurde ? It doesn't work, I've checked the sender pot and that's ok (although it was stuck) AND I've also replaced the wires that go from the pot to the power head. Three of them, they were melted at some point possibly due to...
  6. Ben Clegg

    Evinrude 115 stripdown

    Engine overheating so I change the thermostats .....still overheating so changed the Impeller .Still overheating and now coughing at tick-over. Mnnn .I should have listened to you guys in the first place as someone told me to check engine compression. Checked the compression today and low and...
  7. Ben Clegg

    Yamaha 15HP model ID

    Hi Can anyone help , I need to identify the model to ensure I get the right spares Yamaha 15HP The only number I can find is stamped on a small aluminium plate on the frame and is ....................684CS 012285
  8. Ben Clegg

    EVI 115 Gearbox removal questions

    Hi I need to service the impeller on my Evinrude 115 SPL, can anyone help me with how to disconnect the gear linkage and remove the gearbox? Ben
  9. Ben Clegg

    How best to remove old gaskets

    Hi Im replacing the thermostat on the evinrude 115, managed to get the thing off but am struggling with removing the old gasket ...................any good ides anyone?
  10. Ben Clegg

    Evinrude 115 hp overheating alarm

    Hi Im new to all this so please bear with me................ I just purchased a small (17foot) Fletcher boat with an Evinrude 115 SPL engine. It runs great however if I run it at 3/4 throttle for more than 5 mins the engine overheat alarm sounds. If I then put it in neutral and let it tick over...
Top