Search results

  1. Scott Danforth

    Mercruiser overheating

    you have a blockage or lack of flow from the pump
  2. Scott Danforth

    Building a '93 Caravelle 1750 Classic Bowrider

    spin the selector switch back and forth to clean the contacts. however it should be set to 1
  3. Scott Danforth

    1976 collins craft.I have the boat off trailer and upside down.It has been washed with muritic acid.I am going to sand with 80 grit and use 2 part

    You have a bit to go before you are worried about finish You need to grind back the broken areas and build back up with fiberglass You need to sand down the cracked gel down to good material, then fair and re-gel I wouldn't use epoxy paint unless it's rated for the job
  4. Scott Danforth

    Mercruiser overheating

    Did you find the bits missing from the old impeller?
  5. Scott Danforth

    1988 Rogue 2420

    The more we use the boat, the more things we find need work Hour meter quit sometime this year, courtesy lights quit working, NMEA gateway for fuel level quit working. Replaced anti-siphon. Need to redo the headliner and finish the closet and shelves
  6. Scott Danforth

    I freeze my block so you don't have to!

    20 degrees for 6 hours
  7. Scott Danforth

    Mercury Spanner wrench for tilt and trim

    $50 is dirt cheap.
  8. Scott Danforth

    Used Boat Lift question

    The motors are the cheapest part of a boat lift and the easiest to replace. Focus on the remainder. How new are the cables? Have the gear boxes been serviced? How are the uppers? How are the lowers? How are the sheaves?
  9. Scott Danforth

    Need RPM’s on 383MPI 1970 SeaRay 24’ project

    Also look at injector duty rate and
  10. Scott Danforth

    Winterization of my Commodore 272

    The 290DP was 1988, the DPA1 came out in 1989 ( updated 290 variant) Your 1996 would be a DPC1
  11. Scott Danforth

    What would cause my FSK16 to not be propelled by my Johnson JW10 3hp?

    Replace the impeller before worrying about the gear oil.
  12. Scott Danforth

    No data to vessel view mobile module

    The gateway is between the sensors and the gauges. In this case, most likely the ECM
  13. Scott Danforth

    Volvo AD41 non marine equivalent

    It's a marine engine only that shares a few things with the construction mitors
  14. Scott Danforth

    Click No Start

    Agreed, start wire (yellow with red stripe) is on the R terminal, not the S terminal
  15. Scott Danforth

    Recognize this tower?

    Good luck
  16. Scott Danforth

    Need RPM’s on 383MPI 1970 SeaRay 24’ project

    youre running lean
  17. Scott Danforth

    Guard rail gone slack, sailing cruiser.

    Here is the suncor link https://suncorstainless.com/stainless-steel-hardware/ You can see if it's swagged or the quick connect fittings
  18. Scott Danforth

    Recognize this tower?

    There are two break-aways on the aft leg. Remove the leg, lay it down Regarding brand, look for a serial number tag.
  19. Scott Danforth

    Thinking about an upgrade for the tow vehicle

    A 105 qt cooler full of ice/fish/beer is about 300# A 200qt would put you way over
  20. Scott Danforth

    Thinking about an upgrade for the tow vehicle

    As long as you do not have a cooler full of beer along
Top