Search results

  1. Stinnett21

    Do it yourself Pumpout?

    I've never dealt with a porta potty but I have heard people with cuddy cabins say they drop the shop vac hose through the hatch and suck it out. I guess they think it's easier than pulling the porta potty.
  2. Stinnett21

    Do it yourself Pumpout?

    Buy a dedicated shop vac and leave it sitting outside.
  3. Stinnett21

    Installing one of my alpha one drives and Can't believe I did this.....

    But it will partially block exhaust. If you wind up leaving it there watch your temp closely at higher RPMs. The relief ports can only handle so much.
  4. Stinnett21

    Early 2000's Rinker

    Are you still in Michigan? Has it always been a local boat? If so it's been hauled out every year I presume. Hire an inspector.
  5. Stinnett21

    What size bennet slts.

    That motor should snap that boat right out of the hole. Something sounds wrong. How long have you owned the boat?
  6. Stinnett21

    Non-skid for aluminum floors

    EVA foam boat decking.
  7. Stinnett21

    Starbright mildew stain remover

    I typically use Fantastic spray cleaner, a wet rag and a scrub brush. If it's really that simple I'll try it.
  8. Stinnett21

    2003 Crownline oil reservoir fitting

  9. Stinnett21

    2003 Crownline oil reservoir fitting

    My 1993 A1 G2 had a cap with a hole and dipstick. This was before the lube monitor system came along.
  10. Stinnett21

    Installing one of my alpha one drives and Can't believe I did this.....

    I see that now gotcha. According to chatgbt it is called a shift slide stabilizer tool part #91-865232.
  11. Stinnett21

    Installing one of my alpha one drives and Can't believe I did this.....

    Assuming you're talking about the plastic orange piece that snaps to the stud to hold the shifter in place. How in the world did you get the drive installed with it still snapped on? I have A2 maybe it's different.
  12. Stinnett21

    I/O (Sterndrive) Conversion to Outboards

    Impressive work, thanks for sharing.
  13. Stinnett21

    How to tighten up rack/pinion slack in steering

    I replaced my cable a few years ago due to wear. The amount of play did not improve. I think it's inherently a bit sloppy. Thankfully under power I really don't notice it.
  14. Stinnett21

    How to tighten up rack/pinion slack in steering

    That appears to be the same steering as mine...the back rack system. That amount of play seems normal
  15. Stinnett21

    I/O (Sterndrive) Conversion to Outboards

    Just wondering where is your sound system at? I have the same Sony remote you have pictured on far right. As far as I know their current units no longer support the LED readout that remote was intended to, and used to, display. For my cheap Sony head unit that remote's buttons still function...
  16. Stinnett21

    portable speaker

    JBL Flip 5 is great.
  17. Stinnett21

    View of unloaded trailer with pickups

    I could do that also but I'm afraid I'll forget and jack knife it. Oops referring to Redneck Joes comment in post 35 above.
  18. Stinnett21

    View of unloaded trailer with pickups

    To close the loop on this, I bought a 2023 Honda Ridgeline. I can still the tip of the trailer by turning and looking. Very pleased so far.
  19. Stinnett21

    2010 24' bayliner 245 cruiser with 5.0TKS and Alpha One

    Run it through the Mercury prop selector online. The lowest pitch possible without over revving, tune the motor up, install trim tabs and say a prayer. It's very under powered for that situation.
  20. Stinnett21

    New SEI drive, need a new prop.

    17" 3 blade, in the same prop brand/style, should put you right where you need to be. Instead of a hydrofoil consider Nauticus Smart tabs.
Top