Search results

  1. O

    Have an old OMC Stringer + engine... what to do with it?

    Hi all, Finally getting around to starting a very old project that's been sitting behind my house for far too long now. Old boat (old Starcraft islander) with an OMC stringer and some old (I think 4 cylinder) motor. I have no idea if they run. They ran a long time ago, but after sitting for...
  2. O

    Mercruiser Cool Fuel Module (Gen III) cooling passages routing question

    I have a Gen III cool fuel module. It has a few caps that are bolted on, one over the filter and one over the pump. It also has water intakes/outlets that pump cooling water through. Some of the bolts were really, really corroded in there so I took it to a machinist to get them out. I'm not...
  3. O

    2005 Mercruiser 5.0L MPI (bravo 3) suddenly started overheating

    Hi, I have a 2005 Mercruiser 5.0L MPI (bravo 3) on a 1998 Sea Ray sundancer. Boat has run fine for the most part. Usually runs at 170 degrees all day. Took it out today and it warmed up to 170 and just sat there. Once driving, after about 2 miles I looked down and it was running just a bit...
  4. O

    1998 Sea Ray 250 Sundancer... rain intrusion driving me nuts

    Hi folks, I have a '98 sea ray Sundancer 250. When it rains, I get a gallon or so of water in the bilge (depending on how much it rains). I have been trying to track this down for months and I'm at my wits end. I'm pretty sure this is rain water (rather than a leak or something) because a)...
Top