FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I got ahead of myself!!!!! Had water on lower lower plug and diagnosed to be blown exhaust gasket. Started to remove powerhead and had broken ignition wires before marking. Repaired exhaust situation and now have a rewire situation.
Wires are as followes:
From flywheel Group one: Stator...
The engine starts well. the engine will run up to full RPM and then it will break down to one cylinder. Plugs look good and I suspect a coil breaking down. May need to order one so if someone can check your sources for a year I would appreciate it very much. I also will test the needle seat...
I have a OC216359 which runs well. The only thing is as it runs it starts to increase RPM then it blow out past the reed gasket on the block side of the reed plate. I have replaced the gaskets and torqued to spec. Only #2 cylinder does it. I figured the crank side has low pressure ? at idle but...
