Search results

With a new to you boat that didn't even have the easy maintenance done....make sure to do all the maintenance Pull the drive and inspect the gimbal bearing, u-joints and bellows Check the alignment Change the raw water pump Do a baseline compression test. All cylinders should be between...

And there is the problem You are running lean. Should be 43 psi at every RPM Now find out why Is it an inlet restriction, crud in the pump assembly, etc

Stickies for each forum are at the top of the forum. Best viewed from a computer, not a phone

Lifters mate for life with the cam lobe. I would swap back myself

There is no mechanic in a can. Pull the carb apart and clean it

Why wou you run the boat in winter? Drain your fuel system, fill with proper mixed fuel Check your compression. If it still runs. Buy a lottery ticket

About page 12 of the link in my sig

No wax, with duratec 904

Best to pull the drive and do it right

Pull the drive Put a jack under the motor Pull the front mount Buy 2 belts Replace belt Zip tie spare belt to motor mount when you replace the mount Remove jack Align motor (with the alignment bar you should own) Replace drive

Only one drop of fuel is needed for the motor to spin in neutral. You need fuel to rev under load. I think you have a fuel system issue

You can't move them from outside because of the load holding check valves

Turn key on, press drive down to retract rams. Press drive up to extend

Either a tank onboard, or you premix 50:1

Get one of the torch attachments for a bic lighter. https://www.amazon.com/SOTO-Soto-Pocket-Torch-2019/dp/B005G3PQJQ/

Grey wire at tach, or grounds at the buss behind the helm

bad connections and gunk in your carb.

Generac buys motors from overseas and assembles in Wisconsin. Who's motor and alternator are on the Mitsubishi? most brands are relabeled. Either one will most likely serve your needs in a storm. remember to drain the fuel and change the oil after each use. Generac used to require an oil...

Suggest you borrow a dwell meter.

exactly. that and there has not been a new rochester carb built in 30 years, just bad chinese clones doesnt help.