Search results

  1. circlehook

    1986 22" sail master lower unit midsection

    Hello i have a 1986 8hp johnson sail master I removed the lower unit no problem. But the middle spacer refused to come down the drive shaft is out it ain't that. The shift rod is out it ain't that. The mid section is separated by about 1/2" but no further you would think it should just drop off...
  2. circlehook

    2004 30hp johnson motor mounts

    How do the lower side mounts come apart the rubber end is torn off and just the steel half of the mount is on the side lower housing how are the mounted inflate Bob
  3. circlehook

    Lower rubber mounts 2004 30hp johnson

    Hello how do you remove the remaining half of the lower side rubber mount after the rubber has falling off
  4. circlehook

    Morse controls

    Hello i have a dual mt2 morse control one side is broken, can I buy a single and will it match up to my good side.
  5. circlehook

    Counter rotation conversion kits

    Dies anyone know if there are conversion kits to make a standard rotation, engine to a counter rotating engine. 1998 30 hp johnson/ evenrude Bob
  6. circlehook

    Cable ends

    Hello i have a teleflex 33c cable and lost the female 10-32 with a 1/4" hole cable end does anyone know where to buy another its not plastic, it's metal. I been looking and can not find one. Thanks bob
  7. circlehook

    Deep cycle battries and standard car battries

    Do battries have any effect on ignition systems if there marine or non marine types
  8. circlehook

    1988 force stator 125hp

    Does anyone know the ohm reading for a 1988 force 125hp stator Thanks bob
  9. circlehook

    Idle mixture screws adjustments 135 hp 1990 Mercury

    Hello I need to adjust the idle mixture screws on my 135 hp Mercury I Have a tachometer does this help and is there any sequence between the three carburetors Bob
  10. circlehook

    Early 90 hp Yamaha tachometer wiring diagram

  11. circlehook

    1964 18HP starter

    does anyone have or know where I can obtain the parts to make my 18 HP a electric start engine Thanks Bob
  12. circlehook

    reed valves

    question when a reed valve goes bad will there be a tell tale sign, like how will a 6 cylinder act if one or two were bad. my engine has no mid range RPM with out stalling idle to 1,500 RPM & 2,500 to 4,800 RPM is ok, but in between she stalls, 225 mercury offshore, 1996 2 stroke, thanks bob
  13. circlehook

    Stallling 225 Mercury Outboard

    I have a 225 HP mercury offshore outboard, and it idles good up to 1,500 RPM, and if you can get her up to 2,500 RPM she runs fine all the way up to 4,800 RPM, but between 1,500 and 2,500 she keeps stalling and really no power, every thing from the filler caps right to the primer ball is brand...
Top