Search results

  1. R

    High RPMs but low speed

    Thanks. I talked to my local dealer and he suggested it could be algae build up. It had some build up on when I parked it three weeks ago and I did notice it had accumulated more when I took it out this past weekend. I’m having it cleaned this Thursday. I’ll report back with the results.
  2. R

    High RPMs but low speed

    I have a 2021 VF250 on a 25 ft pontoon. I normally get 40mph at 5500rpm WOT. Boat sat for three weeks in the slip and took it out this past Saturday. Could not get past 26 mph at 5500 rpm WOT. Is there anything other than spun prop or cavitation/ventilation that would cause this?
  3. R

    Johnson 115 lower unit/ mid section leaks water. Is this normal?

    Thanks for all your replies. Sounds like I’m good to go.
  4. R

    Johnson 115 lower unit/ mid section leaks water. Is this normal?

    Is the water leaking from the lower/ mid section normal? Or do I need to replace something?
  5. R

    04' Johnson 115 HP - Water coming from front of engine

    This is a 2004 Johnson 115 hp. I have not looked terribly hard, but when boat is running, I can see water coming out from the front of the engine, just under the engine cover. I took the cover off with the motor running and the water is not inside the compartment. It is coming from somewhere...
  6. R

    Evinrude 18hp Fastwin Fuel Starvation

    The 18hp Fastwin is cutting out when I get to around half throttle and on up to WOT. I can go WOT and prime the bulb and its okay for 30 seconds or so and then I guess the bowl is going dry, starting to cut out intermittently, in which I can prime the bulb and its okay again for another 30 sec...
  7. R

    Trying to replace top crankshaft seal - 18hp Fastwin

    I'm confused as to how to install the top seal on the crankshaft. Does the seal get pressed down inside the bearing? If so, is it supposed to be a really tight fit because I tried tapping it down into the bearing and it didn't seem like it wanted to go. The new bearing is already in the...
  8. R

    66 18hp Fastwin - Reed Plate / Reed Box Torque Settings

    Can't seem to find torque settings for the 18hp Fastwin Reed Plate/Box. Anybody have a definite on that?
  9. R

    66' Fastwin - How to Remove Crankcase Cover

    To split the crankcase, does the head and reed plate cover have to come off and remove (6) main bearing bolts? Manual says to do it, just wanted make sure before I have to pull the head off.
  10. R

    1966 Evinrude Fastwin - Exhaust Cover water leak

    Just got this motor to run (roughly) and water is seeping through the top of the the exhaust cover gasket. Wondering what possibilities are causing water to be inside the exhaust housing. Also, when motor is running it has a bad miss every few seconds. Thought maybe this is related to the...
Top