Search results

  1. H

    was running great until.....79 evinrude 115 hp question

    Was on the water today running about 40 and all of sudden the rpms dropped to about 2000 and I couldn't get the boat past 20. Could it be a fouled plug or? It was all of sudden and the motor ran great all day. Running 50:1 91 octane and quicksilver oil. Any ideas would be appreciated.
  2. H

    removing the tilt/trim motor 79 115 evinrude

    I have to bang on the yellow electric motor to get it to work.Thinking its all corroded in side. Can I remove the motor without taking the entire engine off the boat? Looks liek 2 phillips head screws holding it on.
  3. H

    Evinrude 115hp question

    Just bought a 79 Sportcraft 17 footer with a 1979 evinrude 115 motor. Runs on 3 cylinders, which i knew going into the deal. The guy says he thinks it may be low on compression in one cylinder, but he didnt have it checked. He just assumed this. I will check for spark, and change the plug and...
  4. H

    oil/fuel ratio 1964 evinrude 28 hp confusion

    On the inside of my motor cover, it says to mix 1 qt oil to 6 gallons gas. It also states 1-24. I have been running 50:1 and now i'm concerned about it. Does this mean I should be running 24:1 mix?
  5. H

    1964 Evinrude 28 hp throttle question

    It's a speeditwin, runs great but it seems the throttle mechanism won't got to full position. I am not sure if it's a cable adjustment or what. My old merc had a throttle stop that was a plastic tip on a screw and that motor did the same thing until i backed that screw out and it went full...
  6. H

    1964 evinrude 28hp wiring help!

    Hi all! I just got a great running speeditwin 28 hp. Right now i am using the pull rope to start it because it has not ignition switch or keys, but the wires are all there. I want to hook up the wiring for electric start, but cannot figure out what wires are what. Also, if don't use the wiring...
  7. H

    1968 Johnson 25 Seahawk advice

    I have a chance to buy a 68 Johnson 25hp for 150 that runs good. He says it's a Seahawk, never heard o fthat model but i was wondering if anyone know sanything about these motors, are they reliable? any thing to watch out for?
  8. H

    1968 johnnyrude 55 hp help

    I have a chance to get a 1968 johnson 55 hp that the guy says it runs but runs a little while then stops and he said it starts right back up. He says it's bad gas or the carbs need cleaned. Should i buy it? He wants 100 bucks for it and has a title and controls. I am wondering if you guys...
  9. H

    Wont' go into forward or reverse..Ideas?

    Got a 1970 Mercury 500 50 hp. Ran fine last year but it stopped going into reverse. I can live without it. Well, took the boat out to the lake to test it for memorial day weekend, and it fired right up and ran great. Went to put it in gear (forward) and nothing! I disconnected the cable and...
  10. H

    Is this a good motor to buy?

    I have never owned a Yamaha outboard, but i have a chance to get one. It is a 1985 50 hp, don't know if it's the pro or not. Runs great, but here is the thing, he said it has the oil injection (autolube?) and it does not work and he paid 400 to have it bypassed, something about a chip in it...
  11. H

    Water leaking from spark plugs

    I got a 1970 Mercury 500. I may have been ripped off when I traded a guy for my 35HPto this 50HP. Two things I hope soemone can help with. It starts and runs fine. Perfect in fact. But i noticed some water bubbling out from the spark plugs while it is running. has good compression in all...
  12. H

    Should i buy this boat?

    I come across what i think may be a good deal but not sure. I have never owned a Volvo Penta Inboard before. The motor runs great, th eoutdrive is good. He says it needs all new hoses. Like an exhaust bellows, and a hose that goes around a u joint in the driveshaft? Also all other hoses. He said...
  13. H

    What is a mercruiser 120?

    I'm new to inboards, but just a 1968 Larson in excellent shape except for the motor. The guy said it lost most of it's oil due to a crossthreaded oil drain plug and it started running funny so he shut it down and has'nt run it in 2 years. He proceeded to tear the head off and did'nt know what he...
  14. H

    No ignition key,help with ignition

    I bought a boat and the owner had lost the key. I have a few questions I hope someone can help me with. The motor and controls are a 1970 Mercury 1150 Inline 6 115 Hp. Does anyone know if I can bypass the wires to start it and which ones? He also gave me an ignition switch with a key, but it...
  15. H

    anyone ever heard of Glassmate boats?

    I have a 17.6 ft Glassmate boat, made in Gainsboro TN. I never heard of them and can't find any info onthe net. It seems to be a good and solid boat. Thanks for any info and help.
  16. H

    Advice on new/old boat/motor/tank

    Motor is a 115 hp 1970 mercury 6 cyl outboard. The boat (17.6 Glassmate) is in great shape, but I need to put the new wood in for floor. Has 15 gallon aluminum tank that has the smell of old gas. What do i need to do to flush the tank to clean it, and what do I need to do to the motor to start...
  17. H

    convert open bow to cuddy cabin

    I got a boat for free that runs, it is a 1981 Glassmate 18 foot tri-hull with a 115 hp outboard.Setup with decks in front and rear for a fishing boat, which I just boat for pleasure anyways. I am a bit of an inventer and like to tinker with things. I want to convert this boat and make a small...
  18. H

    Relocate Drain plug for Smart tabs

    The Drain plug on my boat is in a bad spot for me to add smart tabs. Can the drain plug be relocated or is this a bad idea to do that? If not, does anyone have any ideas on how to mount the tabs?
  19. H

    Winterize an outboard?

    I do not have a garage, but I have a 12x12 heated building in which I store my musical equipment in the winter and Ac in the summer. I have heard people say you can just leave an outbaord on the boat all winter long, and I know people do it, but I can't see leaving it on while it gets to -10...
  20. H

    2 issues: Boat "rocking" and Motor not long enough?

    Re: 2 issues: Boat "rocking" and Motor not long enough? Here is a better pic of the Motor and boat bottom. Would really like to know if the position is correct. I think it should be lower, but not sure.
Top