Search results

  1. B

    No Spark

    So, I tested the old switch and there was 100% resistance in the on position but zero resistance in the start position. The new switch seems to be operating properly with 100% resistance in both the on and start position. Then I tested for spark and there was no spark with or without the...
  2. B

    No Spark

    I left the black and yellow attached to the power pack and disconnected it from the ignition switch and I had spark. I also opened the harness between the motor and the ignition, and the wires were good as new? The new ignition switch was brand new as well, so I am assuming it is good.
  3. B

    Switched coils/wires?

    I am not an expert, but I have been watching videos about testing for spark and I have seen examples of where they did change out the coils for testing. As long as your feed wires match the cylinders you are testing.
  4. B

    No Spark

    1974 85 HP Evinrude. No Spark. removed black and yellow wire form power pack and had spark. replaced ignition switch. still no spark. Removed black and yellow from ignition switch and again at power pack and has spark in both tests. Could the power pack be sending too much voltage causing an arc...
Top