Search results

  1. B

    93 200 vindicator and 92 175 intruder part compatability

    Hi- I have a 92 175 intruder (e175glenc) and know of a 93 200 vindicator that is available for parts. Does anyone know how compatable these 2 engines are??? Can my engine accept parts from a 93 200 vindicator or are they very different engines? For instance can I use the starter on either motor?
  2. B

    What are these noises that my motor makes before starting???

    I have a 1992 2.6 Liter (175HP) 60* Looper Evinrude outboard (175GLENC). Before I start the motor I pump the oil and gas bulbs to prime the engine. Then I push the key in and hold it for 2 seconds and then turn the key to start the engine. I hear 3 distinct sound from the engine. The first...
  3. B

    Bad transducer on bottomline TM HR?

    I have a bottom line tournament master HR fish finder (s/n 08281284). Problem is the unit only plots 2or3 lines of data once every 15 or 20seconds...Goes on a coffee break...plots another 2 or 3 lines and then waits another 40 seconds or so for the next data to be plotted. The data recorded is...
  4. B

    evinrude trolling motor speed control switch bad?

    My evinrude 12/24 trolling motor (mod BF4TK serial H02649810) only runs when the foot pedal switch that should let the motor spin slow, medium, or fast is in the fast position and in either 12v or 24v mode. I used to have slow, medium, and fast speed. Is the foot pedal speed control switch...
  5. B

    steaming exhaust port

    Have a 175 evinrude that will blow steam out of the exhaust port (just below the engine cover on the prop side of the motor) while the engine is at low rpms but not at hi rpms. The engine pees runs and starts fine at all rpms. Is it normal for steam to blow out of this port at low rpms???Could...
  6. B

    specific carb anatomy question

    Have a 15 horse evinrude with carb 388275. When I look at the front of the carb with the bowl on the bottom I can see a large hole with a butterfly inside, above it an adjustment screw and to the left of the adjusting screw is a hole. My question is...Should this hole have a metal plug in...
  7. B

    hard to start 15 hp evinrude

    Have a 15 horse evinrude that's hard to start. I have to pull it about 30 times continuously and then it will start up. Runs good at high rpm but will shut off at low rpms...And then after another 30 pulls it starts up. I've tried using and not using the choke. I noticed when I pull out the...
  8. B

    15 hp Johnson won't go fast

    Hi ALL<br /><br />I have 15 hp johnson that starts, runs great/fine at low speed, but as soon as I try to go fast the engine revs up and immediately revs back down again, and unless I turn the gas lever back to slow speed, the engine will turn off. I checked to make sure I don't have a tank, gas...
Top