Search results

  1. kylake

    Wet sanding gel coat

    Can I wet sand boat this weekend,and buff and wax next weekend?Boat will be covered and not used thanks.
  2. kylake

    1990 Evinrude 150hp fuel and primer hose route diagram

    HELP PLEASE!!!! Does anyone have a diagram for a 1990 Evinrude 150hp fuel and primer hose route diagram.Changed out some cracked lines and have all new tees to put back together.Took so long to get all the parts now forgot how some of the hoses go.Stupid me should of taken picture of...
  3. kylake

    twin rack steering

    replace twin cable rack steering to twin cable with one rack behind steering wheel.what i have now is two cables going to motor with each having own rack attached to other ends.what i am looking to buy is two cables at motor end going to only one rack on other end.so if i buy new back mount rack...
  4. kylake

    1990 envinrude 150hp how to remove vro

    How do you remove vro from envinrude 150hp?
  5. kylake

    put screw into plastic gas tank in boat NOW WHAT

    Fixed one thing now big problem.put small screw into plastic gas tank in boat,pulled screw out,drained gas.was going to take tank out but it is under all kind of welded in brackets.its a tracker boat.so now can I get some kind of expoy​ put in hole put screw in and expoy over that?:mad-new: HELP
  6. kylake

    buying used boat with 2001 mercury 50hp 4-stroke but it surging at wot should I buy?

    Looking to buy 2002 tracker pro angler v-16 with 2001 mercury 50hp 4- stroke.boat in great shape,motor clean has low hours.idles good throttle up no hesitation,but at wot it starts to surge.is this a big money problem so I buy or not?
  7. kylake

    2002 tracker v16 is it paint or decal on sides of boat

    The color and name of boat on sides is it decals or paint?got boatt from neighbor but front parts on sides all nicked up from hitting dock.looks like it's a large decal on sides.would like to take off and put new ones on.don't know for sure if it's a decal.Thanks for any help.
  8. kylake

    2002 50hp 4 stroke rough idle

    Motor starts right up,but at idle it wants to die.choke it a little it's fine.do I need to clean carbs?can I just spray carb cleaner in carbs?
  9. kylake

    tow vehicle for 18' bass boat

    Have a 18' bass boat used to tow with old pickup that know has died.wife needs newer vehicle just wounding could I tow boat with mini van.Will not be towing far I am about 4 minutes from our boat launch in subdivision.the farthest would be about 8 -10 miles from house mostly flat road.she really...
  10. kylake

    1979 85hp power trim fit a 1977 115hp

    Will a power trim tilt off a 1979 johnson 85hp fit a 1977 115hp johnson?
  11. kylake

    1977 115hp johnson pee hole

    Can not fine pee hole anywhere on motor.Does it have one?every other motor I have had did.got motor running finally looked to make sure impeller was working but no pee hole anywhere.then overheat buzzer went off so I shut it off.so bad impeller or bad thermostat?
  12. kylake

    tilt locking braket

    Just finished getting used boat redone,took out for testvrun.motor started right up runs good put in reverse and motor came up out of the water.looked at motor seams the locking thing on tilt part is missing.what is this called and can I get one,or what else can I do to keep motor in water when...
  13. kylake

    patch holes in transom from old transducers

    Old owner removed transducers and just put caulk in holes.took putty knife and it came right out.what should I use to fill the holes?also have some small gouges on side of boat less than 1/2 inch,they don't go through fiberglass.could I use same thing to fill that I put in holes?Thanks for the help.
  14. kylake

    what gauge do i need

    Rewiring used boat I got.confused by gauge charts on line.just need to know what gauge wire for battery to switch panel,and gauge for navigation lights,bilge pump,live well pumps,radio.last one trolling motor.thanks for help.
  15. kylake

    1977 johnson 115hp Ignition switch

    Got a 17' bass boat with 1977 johnson 115hp .previous owner broke key off in Ignition.would this somehow make motor not start.had same motor years ago it had a lanyard kill switch but forgot were it was.By any chance is it at end of Ignition switch ?Because on side mount control on this boat I...
Top