Search results

  1. K

    1994 115hp Evinrude V4 thermostat repair

    Any advise on procedure to remove and replace thermostat and gaskets. I know I can do the job, but what is the best procedure getting everything apart? Thank you i do not have the manual. E115TLERC Any help is much appreciated, Thank You!
  2. K

    Water in Cylinder, 1979 40hp merc

    I have a 79 2 stroke 40hp Mercury that started running ruff last fall when pulling up to the boat ramp. Took it home and put the hose on it and found that water was getting into one of the cylinders. Ran on one cylinder. HAven't done a compression test yet. What are some possible causes of...
  3. K

    Bad coil question

    For those of you who have ever had a coil go bad on them on a 2 STROKE, I wanted to know what you motor sounded like when you were able to keep or get the motor to run with a bad coil? Thank You
  4. K

    White Litium Grease- End Cap Bearings

    Anyone have any pros or cons on using CRC White Lithium Grease on end cap bearings? 79' 40hp Merc 2-stroke
  5. K

    Upper end cap bearings

    I have just removed the upper end cap from my 1979 40hp 2stroke merc. I have a used upper end cap that I am replacing it with but I also want to swap the bearings out and put the bearings that were in the old end cap in the new used end cap. How do I pull this particular bearing out correctly...
  6. K

    Flywheel hub help- 79' 40hp 2stroke merc

    I have read sevaeral posts on removing flywheels and have done so a few times on my motor by just removing the 8 bolts because until now that was all I needed to do for what I needed it pulled for. I have don that again but this time realized that I also needed to pull the center hub of the...
  7. K

    79 40hp merc, stator came loose"again"- did damage- need help

    I purchased a boat with a 1979 40HP 2 stroke electric start motor about a year and a half ago. Since I have had the motor I have changed some parts to get it running strong and healthy again. These are the parts that I have changed or replaced: rectifier, switchbox, stator, starter, rebuilt carb...
  8. K

    Replacement Rectifier

    I have had my boat in storage since fall and have known all winter that I needed a new rectifier for this year. So I went to the Merc boat dealer in town to pick one up for when I pull the boat out this weekend to start getting it ready for spring. I have a 1979 40hp 2 stroke electric start...
  9. K

    79' Merc, 40hp, 2-cyl, Ignition Help Please

    A few weeks ago, just got the boat on the water to troll for walleyes:). She wouldn't stay idleing and would die (ran fine WOT), so I headed back in. To make long story short, as I was heading back in she suddenly killed within 3-4 seconds at almost full throttle. Wouldn't start-up afterwards...
Top