Search results

  1. M

    F9.9SH - 1987 Yamaha full throttle issue

    Hello everyone. I Have a Yamnaha F9.9 SH- 1987 4 stroke that i have rebuilt the carb and am having an issue with. Now this issue was present even before rebuild so iam assumming the issue is something else. Starts first pull -Idle comes up high till it warms up. Then it comes down to idle great...
  2. M

    70Hp 1976 evinrude TDC pointer

    Hi wondering if someone could give me an Idea as to how to make sure my Timing pointer is correct. I Have a piston stop tool. Also have the manual, But alittle confused as to the two marks on flywheel and do i turn the flywheel ONLY clockwise for the first mark and continue clockwise for the...
  3. M

    1976 70Hp rude throtle yoke adjust

    Hi everyone. I had A problem awhile back with engine bogging out when throtling up but corrected that as there was a pinched line on numer 2 carb. Now i may have moved the throtle control rod yoke abit and now i have rough idle and it stalles when i place it in forward gear at trolling speed. If...
  4. M

    1976 70hp With CMC tilt (Boggs)

    Hi I Have a 1976 70 hp Evinrude that was running good but had sat for about 2 years. Rebuilt the carbs and installed a water pump. Bench tested (with water hose) seems to run good in and out of gear. Installed it on a 16 foot fiberglass boat. Here`s my problem! Started, idled good, but put it in...
  5. M

    1976 70Hp Midsection Swap

    Hi everyone. I know this topic was discussed somewere in these forums,but I was wondering if anyone has any knowledge of swapping out the midsection of a later model 70Hp with tilt trim to fit a 1976 70Hp. Is this possible? and what model year would work if possible Thanks My engine model is...
  6. M

    1976 70Hp evinrude Tilt trim

    Want to get a power tilt and trim for my 1976 70HP evinrude. What year and model will fit? I have found one for sale, But the seller says This "You will need the proper bracket to replace on your motor to bolt the tilt&trim to. I will remove it from the blown up motor { which is from a 1978...
  7. M

    Tach Merc to evinrude

    Hi everyone. I recently changed my outboard engine from a merc to an evinrude. Know i had a tach with the merc is it possible to use this same tach in my dash for the evinrude? Could the merc tach be riged to work with the OMC control harness. The Omc is three wire and the merc tach has three...
  8. M

    1976 70hp water pump

    Hi everyone. I recently put in a new water pump complete kit. And bolted up the lower end. I also did the tell tale mod and it works great. My question is when i start this motor with the muffs Is water suppose to come out of the 2 small holes on oposite sides of the lower end aswell as some...
Top