Search results

  1. U

    Trim fluid addition quandary...

    I'm sure you guys will laugh at this one, but here goes... I'm sure I have a very slow hydraulic leak in my trim/tilt. Up and down with the switch is just fine, but if I leave the motor up, it gradually travels down (approx 2"/hr). Here's the laughable part: I'd love to find a way to top off...
  2. U

    Hummin Fish Finder

    I wanted to take a quick moment to thank everyone for their help on my "FishFinder vs. DepthSounder" topic. Ultimately, I had bought the Humminbird Piranha 4 and installed the transducer before the last poster mentioned that the Humminbirds are notoriously crummy. Fortunately, the unit has...
  3. U

    Fishfinder vs. Depth sounder

    Several neighbors in my area have suggested that going out into our river and bay area would be insane without a depth reading (lots of mud, shallows, shoals). As I'm browsing through the WestMarine catalog, I'm trying to figure out why I would spend $150-$250 for a depth sounder, when I can...
  4. U

    Where can I find dial indicator?

    Hey akk,<br />I'm trying to set the timing on my 1992 Merc 60HP. The manual recommends using a dial indicator to find TDC, then backing off to get to 0.451" BTDC. I'd like to find a dial indicator with a spark plug thread adapter so I don't have to 'rig' a holder on a normal style indicator...
  5. U

    Mercury Shift Problem

    Motor : 1992 Merc 60HP S/N:0d095933<br />I've just changed the water pump in the above-referenced motor. While I was in there, I replaced the shift shaft bushing and seal (the seal was corroded looking). The shift shaft never left the lower unit, though. Upon reinstallation of the lower...
  6. U

    Fuel filler ground connection

    While working on my 16' SeaRay BR, I replaced the fuel filler neck and hose (with same part as OE - Perko w/ integral ground connection). Lo and behold, after doing all the work on the filler end, I wanted to check the ground connection at the other end of the wire. It was just flopping...
  7. U

    Merc 60HP Powerhead swap

    I recently acquired a used powerhead for my 1992 Merc 60hp. The S/N for the replacement is newer than my original, and has some (mostly) very slight differences. The only one I haven't been able to overcome is the oil injector. The bolt holes from my original oil injector don't line up with...
Top