Search results

  1. C

    Outboard bracket mounting specifics - question

    Hello. I have a 26" setback, 17 degree angle, Stainless Marine brand bracket that is on a donor boat, which I am going to transplant to a 25 ft Aquasport center console (1979 246 CCP). I know that the cavitation plate has to be about 1 inch above the bottom of the boat for every foot of bracket...
  2. C

    Evinrude Johnson 1990 225 Looper LAST RESORT flywheel removal tip

    Hello Everyone, I made a discovery today (i think??) that hopefully will save you alot of time someday. I restore late 80-early 90's crossflows and loopers as a hobby so I am quite familiar with them. Lets say i am a professional amateur. So I got this 1986 225 Looper. The scary thing was it was...
  3. C

    1991 Johnson 225 carb jetting

    Hello Guru's, I have a txeic, 1991 225 looper. I have one cylinder .030 over (#4 I believe). Should there be different jetting for that cylinder? and if so, Is it the corresponding carb that is right in front of it (not the opposite side like on crossflows?)? I have all #62 main jets, but the...
  4. C

    1991 225 blowing rectifiers

    Hello, I have a TXEIC, 1991 225, Johnson. for fun I buy tired motors and refurbush them... honed, new rings, all soft goods replaced, new check valves, etc. I am an advanced tinkerer and just short of professional. Ive refurbished about 9 early 90's loopers in the last 3 years. I feel I have...
  5. C

    Prop for 1988 Evinrude 175 on 20' center console

    I have a basic 1978 Aquasport 200ccp Center Console (no tee top or heavier equiptment) with a 1988 Evinrude 175. I just got the motor this season. It seems like the motor is straining and a bit bogged down in the upper rpms. twice the motor came to what seemed like a catastropic clanking stall...
  6. C

    converting 1988 150 to a 175-carb question

    Hello, took a evinrude 175 powerhead and put it on a 1988 150 body. I used everything off of the 150... carbs, electrical, etc. My question is can I use the "1 1/4" carbs off of the 150 and rejet them or does the 175 require the 1 3/8 carbs?
  7. C

    Evinrude 1986 225 Carb flat spot/stalling

    hello, I am stumped. I have a 1986 225... new stator, timing base, VRO pump and power packs, carbs rebuilt, good compression (almost 110 lbs per). It idles a bit rough at times and sneezes and sometimes stalls. This is corrected by bliping the choke a bit. Secondly when i throttle up, it will...
Top