Search results

  1. S

    1992 Evinrude 150hp EXEN will not run correctly

    Back again.... Back to square one... Took the boat out today and it will not run when I give it any throttle, it idles kinda rough but just bogs down. This is getting very frustrating, as it has to be something simple. It seems like it's not getting enough fuel or it's in limp mode. I have...
  2. S

    Evinrude fuel pump conversion kit

    I have a 1992 Evinrude 150hp EXEN. My VRO is leaking from where the bottom fuel line is attached. I have replaced the fuel line, put on a SS clamp, still leaks, I think it may be cracked can't afford to fork out several hundred bux for a new one. I want to put in a conversion kit. Does anyone...
  3. S

    1992 Evinrude 150hp EXEN T-stat seals

    I need to replace the T-stat seals on my motor. the old ones were O-rings, the new ones I ordered are flat and are totally different, perhaps they were improved for the better. I attached photos of them. My 4 questions are : 1. has anyone changed these and used the new style as they are a tad...
  4. S

    1992 evinrude 150 EXEN vacuum line diagram

    I have a couple vacuum lines that go no where, they just end and are not plugged. I have tried to find a vacuum diagram and have come up short. The manifold balance tube drains just hang down I assume, to drain. The picture shows a tee that comes from the bottom front of the block, hard to see...
  5. S

    1992 Evinrude 150 Oceanpro

    I recently purchased a 1986 20' Aquasport center console with the 1992 Evinrude 150 Oceanpro on it. I pulled the thermostat caps to see what the t-stats look like after being in salt water and there was no t-stats just a hole where they go. The VRO has been removed and everything bypassed...
  6. S

    Trim motor removal

    I need to remove my trim motor on a 93 200 hp yammie. Do I need to remove the engine to do this??? Also do not buy a Clymers manual unless you need foder for the fire.
  7. S

    Magic tilt trailer floats

    My trailer floats and it makes it quite difficult to load It is aluminum I beam dual axle with with wood skids any ideas how to solve the problem.
  8. S

    yamaha 93 200 hp trim motor

    My trim motor is sticking so I have to tap it to get to run,time for a cleaning. I ordered a Clymers ten minutes ago and won't get it till the week end. Is this book worth the money?? Anyway my ? is to drain the hyd fluid does the motor need to be up or down as I would like to get it apart for...
Top