Search results

  1. N

    Boat steers sharply to the right

    16ft J Carolina Skiff with Suzuki 40hp goes right when wheel is released. Trimtab is adjusted all the way. Doesnt engine height have some bearing on this steering problem? Engine has to be in a negative trim position when starting out or it will not get on a plane. <br />Thanks
  2. N

    OMC parts needed

    Good ole UPS dropped a 1987 4hp JOhnson I had shipped to me and broke the motor cover , starter cover which the motor cover attaches to and the carry handle. Dealer says the first 2 are not available.<br />Maybe someone has them in stock.<br />Needed are # 0283392, 0397393 and 0397227 which is...
  3. N

    55hp 78 Evinrude wont idle

    Runs ok at high speed<br />At idle speed it will idle for a short period, start slowing down and then stop<br />Restarting is hard. Throttle trim must be wide open and engine must be choked.<br />Low speed jets, holes ,chambers, are clear in carbs. I can run a small wire into them all with no...
  4. N

    Bearing Buddies, questionable value ?

    I replaced my trailer axle in the last couple of days. I put the hubs back on today and got to thinking. How can the grease from a Bearing Buddy get to the back bearing. I dont see how. The outside bearing and washer will prevent it. The only way for grease to get to the back is between the...
  5. N

    Tire splits question

    I bought two new 4.80 x 8.00 tires and rims a few months ago. They probably have less than 200 miles on them. I noticed yesterday there are splits in the sidewalls. One tire has several and using a straight pin I found that one is 1/8 in deep. The splits run perpendicular to the rotation. Some...
  6. N

    Boat Weight ?

    Does anyone know the approximate weight of a Custom Craft 15 ft. open, side console boat or similar type boat?<br />Thanks
  7. N

    Boat weight?

    Does anyone know the approximate weight of a Custom Craft 15 ft. open, side console boat or similar type boat. <br />Thanks
  8. N

    Whats the name of these things?

    I talking about those big "Trim Tab or Wing" like things that connect to the foot of an outboard. They get the boat on a plane faster. Anyone know?<br />Thanks,<br />Dave
  9. N

    PROP size and pitch???

    Can anyone determine the size and pitch of this prop? Fits OMC, no Mfg. Numbers on prop are:<br />BP 34.<br />L 236<br />28 BP 691<br />Thanks in advance,<br />Dave
  10. N

    Device for raising OMC motor

    Years ago I made a device for tilting my motor. It hooked into the handhold . You could buy them also but who had any money. Does anyone know the name of these and if they are still available?<br />Thanks
  11. N

    1978 55hp Evinrude- overheating

    Person I got engine from said it hadnt run in 6-7 yrs. He obviously didnt ever flush it out, salt water. Alarm went off while using the flusher. Replaced water pump assy. Pumping more but still overheats. Water from Pee hole is very hot but water from foot isnt even warm. Starts easily and runs...
Top