Search results

  1. S

    Baha Cruiser 271 Fisherman

    I am looking at a 97 Baha Cruiser 271 Fisherman-Volvo Penta SX 5.7L. I have never owned a full inboard boat. She needs a good cleaning. Iwill not get a sea trial,This is a auction boat. Can anyone tell me about this boat. And what can I expect in gph.
  2. S

    Red Snapper Season 2010

    Anybody know the verdict for Red Snapper Season 2010 Gulf Coast Alabama to Florida?
  3. S

    Major Question on Rebuilds!!!!!!

    My question is simple. How many times must you rebuild a carb, so that when get done you have enough parts to make 2 ?????. This question also goes with complete rebuilds on motors. Personally I have enough parts for 2 carbs on my lawn mower, and a have started a box of parts for my...
  4. S

    adjusting duel carbs? Force 120

    Are there any certain steps in set-up and adjusting duel carbs. Force 120
  5. S

    98' 120 hammering/knocking

    Motor runs stong and idles good. At 4200 to 4800 it makes a hammering sound. Over 4900 to WOT runs strong. Any ideas?
  6. S

    Time to Repower

    As red snapper season comes to a close. I want to give up my 98' 120 Force for a 130 E-Tec. And put it on a 98' Trophy Cuddy 19'. Need to hear some feed back. I use the boat in the Gulf 8 to 15 miles off shore. And if no play money that month we are in a deep water lake pulling my kids in a...
  7. S

    trailer bearings-water

    I have water in my oil trailer bearings. I bought new seals and will clean up the bearings. THE QUESTION- What type of oil do I use?
  8. S

    Oil Bearings

    It looks like I have some water in my bearing oil. I want to clean and change the seals. What type of oil do I use to re-fill? Also General tightness of axil bearings are the same between grease and oil? Alway heard trailer bearing should have loose fit up?
  9. S

    garboard plug

    I have a 98 Trophy. The garboard flange is loose. I want to take the 3 screws off and reseat the flange. Question I have heard people using Gorilla Glue injected into the old screw holes, when putting it back on to prevent strip out. Or just use the Tex-marine hardening chaulk.
  10. S

    Wires Hanging

    Cleaning motor to replace plugs, found two wires not connected to anything. One is dark brown white stripe, and the other is tan. they look like they would connect to one another. What are they? Need to be ready for red snapper in the Gulf next month. 1998 120hp force on 19ft trophy.
  11. S

    120 force carbs

    OK Old Salts, I have a 98' Force 120. I'm getting about a table spoon of gas dripping out of both carb air intakes. This is during a 20 min idle to flush out motor. Can it be adjusted. Red Snapper in 6 weeks gotta be ready!!!
Top