Search results

  1. Minnow00

    1994 50 HP Mercury ELHPTO water pump

    I understand that on this motor cooling water is expelled with the exhaust, yet it does have a small outlet on the back of the engine that streams water out. Mine has a week stream and always has since I have had it over the last six years. Does that indicate a problem? The motor runs fine and...
  2. Minnow00

    1995 Mercury 50 hp 2-stroke

    My engine started smoking excessively probably because I operate at slow speeds so much. So I decarbonized the engine this year and replaced the oil with synthetic. I read here that synthetic oil smokes less so I filled it with synthetic oil. Question is do I need any linkage adjustments to use...
  3. Minnow00

    1995 Mercury 50hp ELPTO oil flooding lower carb

    Why would two cycle oil flood the lower carb from the reservoir when the motor is in tilt for any length of time?
  4. Minnow00

    1994 50 HP Mercury ELPTO Outboard oil leak and smoke

    Noticed oil slick on the floor under the prop when took the boat out today. Motor oil leaking out from the lower exhaust. Put it in the water and started it. Lots of smoke and sounds like one cylinder is miss firing. What could cause this? SN G025398; can't find any model info other than this on...
  5. Minnow00

    1993 Yamaha 6MLHR Has a ton of air coming out around the propeller.

    My small 6hp Kicker motor has a lot of air coming out of the prop area when I set it down and run it. It doesn't clear up when it is run fast or slow. Seems like something is wrong. Seal? Not sure. Any help would be welcome. Motor runs great, even moves the boat but all that bubbles can't be...
  6. Minnow00

    Bearing head seal removal 1956 Johnson FD10

    I've got just one last seal to get out and replace. Will this bearing head seal pry out or will I have to dremel it out like I did for the drive shaft seal?? Any body know the best way to remove this seal?
  7. Minnow00

    1956 FD10 Lower Unit Shift Bushing O-Ring

    :confused:I finally got brave enought to chew out the drive shaft seal on my FD10 Johnson, using (as suggested on this site) a dremel tool. That worked. My question is looking at the shift seal and o-ring since I have it all apart, should that o-ring be replaced? Can it be removed and replaced...
  8. Minnow00

    1956 FD-10 Carb spitting fuel out side!

    I've been having problems keeping my motor running. Dies off after warming up. When she stalls it spits fuel out of the small hole indicated. Is there suppose to be one of those round bee bee like plugs in this hole?
  9. Minnow00

    1956 FD-10 lower crankshaft seal question

    If the seal starts leaking water into the power head what would the first symptoms be on engine operation? I presume a guy would have to remove the power head to check the seal?
  10. Minnow00

    Trolling 1956 Johnson FD-10

    I got this 15 hp this spring. It's good looking and clean. Seems to have been taken care of pretty well. So far I have referbished the whole fuel system, tank, hose, carb kit and the whole shebang. I even found and put in a new low speed carb needle. I like to troll. I mix the oil 24/1 and add...
  11. Minnow00

    Carb Needles 56 FD-10

    I'm putting in a carb kit on my vintage 1956 15 HP Johnson and the needles look a bit worn. I'd like to find a Low Speed pn 303945 now discontinued. Engine trolls good and has good WOT too but I must readjust the carb each time I change speed. I hope the carb kit takes care of this but am...
  12. Minnow00

    Drive shaft 1956 Johnson FD10L

    My gearcase has started to leak so I pulled the lower unit to inspect the seals and check it over. I lifted the drive shaft about 1/2 inch to see if there were any wear on it. I didn't see any and pushed it back down in place and went to the SELOC manual. While reading it said not to remove the...
  13. Minnow00

    Gear case seal kit for 1956 Johnson 15 hp FD10L

    Anybody have a part number for the lower unit seal kit for my old Johnson? I've looked around and can't seem to find a part number for the seal kit. I've got numbers for each separate seal but who wants to buy them that way. I've seen in the forum others mention sierra but unless the 15 takes...
  14. Minnow00

    1956 15 HP Johnson SeaHorse Model FD 10 Long

    Recently I picked this engine up and have had it out several times. It seems to run like new except for the duel line pressure fuel system. Motor needs to be pumped at the tank when fuel gets low to maintain pressure so I presume I have a leak. Since it's time to either rebuild the original...
Top