Search results

  1. D

    Hard/impossible starting

    1996 5.0L mercruiser.it's got good spark,the timing is at 10 btdc,good fuel supply but it's a nightmare to start. it'll nearly flatten the battery before it fires up(if it fires up).when it does eventually go,it runs great. The problem seems to be that the fuel isn't getting into any of the...
  2. D

    Volvo penta KAD32 P wont rev past 2500

    My volvo penta KAD 32 p wont rev past 2500 when it's in gear. when the throttle is pushed forward it will rev to 1500 and the compessor cut in but after the throttle handle has gone past 1/2 way the revs wont rise past 2500. I've disconnected the throttle cable and tried it by hand and the...
  3. D

    force 90 power trim/tilt bleeding

    I just got a replacement PTT pump for a '91 force 90. When I bought it I was told it was self bleeding.I am beginning to suspect that this isn't the case. It's got a manual release valve,which I would have assumed to have a screw slot but it's flat,held in with a circlip. I downloaded the...
  4. D

    johnson 40 4 stroke lack of revs

    why will my 2005 johnson 40 not get full revs in forward gear but it will do max revs in reverse? It was all working fine then overnight it went wrong. any ideas would be much appreciated
  5. D

    '87 yam 20 jumps into forward gear

    my 1987 yam 20hp 2 stroke jumps into forward gear if you give it a rev in neutral. It doesn't have to be wild revving,1500 revs and it'll jump into forward. The gear selector doesn't move when it does it. It's also really hard to get in reverse and jumps out of gear when given some revs. I've...
  6. D

    volvo penta aq131a No Spark

    I have a '86 Bayliner Trophy withn a volvo aq131a. The timing belt went a couple weeks ago. have replaced the belt according to the manual.While it was in bits I thought I may as well change the distributor cap,rotor arm & points. Everything is installed correctly but it wouldn't fire.There was...
  7. D

    Johnson 50hp 4 stroke

    I have a 2003 Johnson 50hp 4 stroke, BJ50PL4SR, serial number S 1802****, with a 2200uF capacitor( see attached pics) soldered to a grey wire and a black wire just below the engine control module. This engine was part of a pair.The other engine also has the capacitor but it's only attached at 1...
  8. D

    Mercury 75hp 4 stroke carb wanted

    Hi I live in Scotland and have been looking for a 2nd hand bottom carb for a 2002 Merc 75/90 4 stroke, serial OT506***. Does anyone have one or know of a breaker that might,either in the UK or US. Thanks
  9. D

    Diesel Outboard

    Hi Can anyone spread some light on how to turn a right hand rotation Yanmar D27 into a counter rotation. Can it be done? I have 2 right handers that I would like to put onto 1 boat Thanks
  10. D

    Yamaha 50hp CDi

    Hi I have a 1987 Yamaha 50hp 3 cyl. I'm only getting a spark to the top plug. I've tried 3 sets of plugs and still only get top cylinder. I've tested the HT coils and all three are working.I've tested the pulsar coils and they are between 340-358ohms,which the manual tells me is fine.The...
  11. D

    Fuel prob??

    Hi I have a 1988 Johnson 40hp, BJ40TLCUD. It's got a problem with fuel in the top cylinder. It starts ok,goes into gear but the top cylinder isn't firing. There's good spark,I have swapped coils(top to Bottom),swapped plugs,I even swapped the top carb with the bottom one.I changed the reed...
  12. D

    Gearbox noise

    Hi I have a 88 yamaha 70hp. It ticks over perfectly,revs freely out of gear,runs fine in reverse but in forward gear it runs in a jerky manner like there's a tooth(or part of a tooth) missing in the gearbox.It starts as soon as it gets above idle speed. Likely cause?? & is it hard to fix??
  13. D

    Mariner 40hp age

    Can anybody tell me the age of my mariner 40hp,2 cylinder,twin carb, serial number 6E 69018189?? (it's a bit worn down).It's manual start but can I add a charging circuit to it,and if I can,how hard is it to do? Thank you
  14. D

    Johnson 4 HP age

    Hi. I have just been given an old 4hp johnson. The I.D. tag reads BE4RCUD and B?1512717. Anyone any idea the age & where I can get a manuel for it. There seems to be a few parts missing + some wires that aren't attached to anything. Thanks
Top