Search results

  1. I

    2005 Trophy Pro 2359 Water in Fuel

    2005 Trophy Pro 2359 Water in Fuel April 21st, 2015, 08:48 PM All, I read a comment from a guy about a 2007 Trophy that thought he was getting water in his fuel through the filler cap. Has anyone else experienced this? If so, was the fix as easy as an o-ring on the cap? Or would you...
  2. I

    2005 Trophy Pro 2359 Water in Fuel

    All, I read a comment from a guy about a 2007 Trophy that thought he was getting water in his fuel through the filler cap. Has anyone else experienced this? If so, was the fix as easy as an o-ring on the cap? Or would you recommend replacing the cap with an after market one? My current...
  3. I

    Trophy Pro 2359 Cover

    I'm looking for a prefered cover for my 2005 Trophy Pro 2359. Anyone have any recommendations? Thanks, Kyle
  4. I

    2005 Trophy Pro 2359

    I just bought a 2005 Trophy. I'm switching from a 21ft SeaPro CC, so I'm looking forward to the all weather boat. The original owner only put 90 hours on the boat, so I'm looking for some advice and thoughts about the boat. What types of things should I watch out for with the...
  5. I

    99 Ficht 225 Hard Start/Rough Idle

    I have a 99 Ficht 225. This has been a great motor. This year it has started to run rough at idle and is progressively getting worse. Now it's at the point that I have to almost give it full throttle in neutral to start, it takes a long time to warm up. Even with throttle at start up it...
  6. I

    1999 Evinrude 225 Ficht Flywheel Replacement

    I have to replace the flywheel on my motor. I know I need a puller to take the old one off, but is there anything special I need to put the new one on? Also, any comon reasons why a starter would chew 5 teeth off a flywheel? When I bought it used the guy told me of a few teeth missing but the...
  7. I

    86 Evinrude Kill Switch

    I've been doing some work on my kicker motor. One thing the guy did that I bought it from was cut the kill switch wires so he could use an extension handle. I don't have the extension, so was looking at putting the wires back together at the throttle. I spliced som e wire in to make it fit...
  8. I

    1986 Evinrude 8 HP Water Passages

    Been working on my kicker, replacing impeller, and trouble shooting why it wont spit water. Got another question. I took the lower unit off and was blowing through the passages from the top of the motor down through the mid section pipe that connects to the lower unit pump housing. When I...
  9. I

    Impeller Key/Pin

    Does anyone know how you could lose the impeller key/pin while operating the motor? I have a 8 HP kicker and when I ran it at home to test it out it pee'd fine. Took it out the other day, started it up and within 10 to 15 seconds it stopped peeing. I took it apart and the impeller looks fine...
  10. I

    1986 Evinrude 8 HP

    Need some help finding an impeller replacement kit for my kicker. Can't seem to find one on the site. Also, when I dropped the lower unit and looked at the current impeller, it was intact but a little rough. The other problem I have is one of the bolts broke off. What's the best way to get...
  11. I

    Multiple Transducers (two side by side)

    Hello, I have a question about mounting two transducers for two separate units. I've tried searching the forum but have not found much if anything on my question. Basically, I have a 21 ft SeaPro. I already have a Lowrance LMS 350A on it. The sounder works great and I don't plan on removing...
  12. I

    SeaPro 210CC Guages

    My guages work fine, but the panel screws that hold it onto the center console are beginning to strip out. I think I'm down to only 4 that hold. Is there anything I can do to fix this? Is there some kind of fastener I can buy to put over the stripped out holes for the screws to go into? Thanks
  13. I

    Circuit Breakers

    I'm trying to find out some info about my push button circuit breakers for my 99 Sea Pro. My CD player wont turn on and I noticed the push button is stuck in. When I turn the toggle switch on, the red indicator light comes on showing power, but CD player nothing. I removed the cercuit breaker...
  14. I

    GPS/SONAR Combo LMS-350A

    I have this GPS/Sounder combo on my 99 Sea Pro. Sounder works great but GPS is intermitent. Sometimes it works fine, sometimes it won't get a signal. Any idea why that might be? My boat only has one battery and I think this might be a reason since the GPS and all other electronics are connected...
  15. I

    CD Player not working

    I hooked up new speakers to my CD player and took the boat out. Sounded great all day. Took the boat home, went out to the lake the next day and nothing, the CD player won't turn on. When I hit the Aux switch the red light comes on like normal, but nothing at CD player. Under the switch...
  16. I

    99 Evinrude 225hp Ficth

    I have a 99 that came on my Sea Pro I just bought. The guy I bought it from said he had it serviced last year but he had not run it in a while and the fuel was old. When we took it for a test ride it started great, ran great except for one spot in the throttle that the motor started to act up...
  17. I

    Shurflo Livewell Pump

    I have a 99 Sea Pro and the livewell and washdown pumps, both Shurflo are broke. I can't figure out how to get the live well pump off. It's connected directly to the bottom of the hull where there is a pet **** to open up to let water in. Can anyone tell me how to remove it, I don't want to...
  18. I

    Navigator OB Trolling Motor 24V

    I just bought a boat with a navigator trolling motor. It does not work, so I'm trying to find a place that will repair/rebuild it. I opened it up and it's a mess inside. Real dirty. I think it could be rebuilt by a shop the rebuilds starter motors, but not sure. Anyone know who makes them...
  19. I

    1975 Merc 850 Power Tilt & Trim

    I've had my PT&T unit off for a while now. I took it off because it was not working and I wanted to clean it up inside. I took the armature out and it was nasty and I notice a wire rusted off the case on the inside. Does anyone know of a good place to send it to have it rebuilt? Or would it...
  20. I

    1975 Mercury 850 Thunderbolt Imperller

    I just dropped my lower unit to replace the impeller. Very easy to do, especially after I found the hidden bolt. Anyway, as I dropped it down I didn't see where the thin black tub came from at the back of the L.U. I do remember I could see it when the unit was put together. So that is where...
Top