Search results

  1. N

    Negative ground

    I have a 93 Lund Tyee 1850 I was working on and hit a hot wire to the hull and got a spark. I don't know if the hull is supposed to be grounded, or getting grounded from the motor being bolted on, or I have a problem somewhere? Thanks for any help.
  2. N

    1989 8hp Evinrude rewind starter removal

    The cam follower on the carb broke. The rewind starter needs to come out in order to get to the screw to replace the follower. Does anyone know if the starter can be moved/removed without the spring unwinding? Thanks for any help
  3. N

    Yamaha 6x0 remote control box

    I have a Yamaha 6x0 remote control box. I think the throttle opening adjustment stopper bolt needs adjusted. When I go from neutral into forward, I have to move the throttle lever quite a bit before there is a increase in rpms. The manual shows the adjustment bolt. Would this be what I need to...
  4. N

    Winch

    I have a 1993 18.5' Lund that weighs around 2000# when fully loaded. It sits on the original K-Dee trailer it came with with carpeted bunks and a 1700# winch. It is a drive on trailer, but when I am at a place where you can't power load, I can hardly crank the winch to get it loaded. The 1700#...
  5. N

    integral hubs

    Hi, I bought a old 14' sea king with a Montgomery ward trailer. The trailer has integral hubs on the wheels. Everything I read about them is to buy new hubs and convert to wheels with lugs or replace whole axle with new one with hubs. The tires are 4.80-8, I can buy a spare with a integral hub...
  6. N

    wet transom

    I have a 1993 Lund Tyee Grand sport 1850. I was drilling holes for a transducer and noticed the wood shavings were damp and a couple drops of water came out. I searched wet transoms but they are all for fiberglass boats. What are options for aluminum transoms? Transom is solid and when I stuck...
  7. N

    fuel tank vents

    I have a 1993 Tyee. There are 2 vents on the side of the boat. Are both of these venting the tank or is one for letting air in as the fuel level drops? When filling I have had gas only come out of one of them. Also, last year when I accidently filled the tank to the top, then put the boat in the...
  8. N

    windshield stop/bumper

    I need a windshield stop/bumper for a walk thru windshield that is around 3 1/2" in length. Anyone know where to find one that long? Thanks
  9. N

    1993 tyee grand sport baitwell

    I use my baitwell to keep a small cooler and other things in. i can't keep water from coming in. the drain hole is a little bigger than the livewell drains. Is there a different plug for the baitwell? I wrapped teflon tape around the plug and that helped some, but a little water was still...
  10. N

    baitwell drain

    I have a 1993 Lund Tyee Grand Sport that I bought this past winter. I had it in in the water for the first time this past weekend and was checking everything out. I turned the livewell/baitwell pump on to make sure it worked. When I pulled the drain plug to drain the baitwell in the rear of the...
  11. N

    using 2 fish finders

    I have a Hummingird 757c on my dash and would like to install another cheaper fish finder on the bow and have both on at the same time. I have a Humminbird Xtreme 160 out of a older boat I though about using. I contacted Humminbird and they said they both run at the same frequency and will...
  12. N

    gas cap strap

    The plastic strap that keeps you from dropping the gas cap in the water is broke. Can they be replaced or do I need to buy a whole new cap assembly? Thanks
  13. N

    floor repair

    I have a '93 1850 Tyree Grand Sport. It has some soft spots in the floor. In order to replace the floor, does the dash, live wells and everything need to be taken out of the boat or can I just take out sections and replace them? I'd rather not have to tear everything out and replace the whole...
Top