Search results

  1. S

    motor guide no reverse

    2006 24 volt tiller handle will not reverse, I was told that it needs a rotary switch, any advise greatly appreciated
  2. S

    e-tec 40hp oil use

    I purchased this 2016 40hp e-tec used... I have burned about 9 gallons of fuel it has only used 1/2 pint of oil is this normal? thanks
  3. S

    my 1989 30hp yamaha is overheating, alarm goes off, motor is pissing strong, i check my thermostat \, it is missing, Could this cause to run hot?

    is there any other reason that causes it to get hot?
  4. S

    30hp 1989 yamaha firing problems?

    this motor starts rite up runs perfect until i take off, runs fast and smooth for about 5 minutes then suddenly looses power and runs like it is about to jump off the boat. Anyone run across anything like this? Maybe electric? gas? any suggestions greatly appreciated
  5. S

    30hp yamaha outboard not firing one 1 cylinder

    i have 1 plug that is very slightly firing, new plug, and new coil still tiny fire, any ideas where i might check next any suggestions greatly appreciated, thanks guys
  6. S

    1988 30hp yamaha breaking dowr

    this motor will take off, run wide open for a couple hundred yards then start choking down will not take gas, idles ok but will not go. acts like timing is out. can stop for a while it will go a little ways then mess up again. I do not where to start. plugs look good any suggestions or ideas...
  7. S

    carb leaking fuel when primed 48 hp johnson

    i have replaced the float, the needle and the seat. when i pump it up fuel pours out. I have no idea how this happens when i know the float, needle and seat are good, with the carb off i can blow and float works as it should. any ideas suggestions greatly appreciated.
  8. S

    trim relay wire diagram

    I cannot find a wire diagram for the 5 pin relay any info greatly thanks guys
  9. S

    jack plate wiring

    I am mounting a jack plate with tilt it has 2 wires, what will i need to wire, is it possible to work without relays? any help, ideas appreciated, thanks
  10. S

    6hp evinrude compression?

    i have a 1973 6hp evinrude question, what should be good compression? thanks guys
  11. S

    1988 70hp yamaha trim motor

    my trim locks up, just clicks, up or down, when i tap on the motor it works again,. is this something i can repair, or do i need to buy a new motor. this motor has set up for a long time. thanks guys
  12. S

    1975 25hp evinrude little spark

    trying to bring this old motor back to life, it has very little spark, almost none at the plugs. where should i look first? thanks guys
  13. S

    1986 40hp yamaha oil to gas ratio?

    I have removed my oil injection, do I mix 50 to 1 or 100 to 1 thanks for any info
  14. S

    40hp yamaha trim wiring diagram

    Is there anyplace i can find a wiring diagram for tilt and trim? thanks
  15. S

    johnson motor year model

    i cannot find a year model the model is mc-12a any one? thanks
  16. S

    yamaha 2000 25hp f25eshy no fire

    motor was running fine when i put up for winter. today it will not fire. fuse is good kill switch is connected, i do not no what to check next. any ideas or suggestions greatly appreciated. thanks guys
  17. S

    1990 40hp evinrude

    is there a way to check the stator not running? thanks guys
  18. S

    evinrude carbs

    i have a 90;s 40hp evinrude carbs have a black plastic top. When i pump the bulb, gas shoots directly out of the vent in the black plastic, the lower one does not.whats up? thanks guys
  19. S

    2001 150hp mercury

    this motor starts,idles,runs perfectly. After running 30 minutes or so engine dies.Will not start without fast idle wide open. Try to pull back on the gas it goes dead. Like it will not run when motor warms up.any ideas greatly appreciated. thanks guys
  20. S

    77s model 15hp evinrude

    It starts rite up, runs great for a few minutes, then goes dead. Then it will not start at all. Plugs fire 1/2 inch. after cooling or waiting a while, it will start instantly. runs goes dead again. So it always has fire and fuel. I don't know???? Any ideas or answers greatly appreciated...
Top