Search results

  1. T

    Sounder function

    At what speed should I expect my sounder to stop functioning. I have a Navman 4350 sounder, which performs well, but at any speed above a fast idle, it ceases to work. the transducer is mounted as per the manafacturers specifications, but the old sounder had a drop down plate mounted to the...
  2. T

    Navman Fuel Flow sender

    Has anyone installed a Navman fuel flow sender in their boat, the type that connects to your GPS. I am unsure if I can put a fuel guage in my tank and need to keep track of fuel level. I have a 75 ltr plastic tank with no fittings for a sender unless i cut a hole in the tank, then have to screw...
  3. T

    Rule bilge pump amperage draw

    I have a Rule 360 GPH bilge pump that I want to connect to mains power through an inverter/converter, what is the amperage draw on these pumps so I know what converter I need. The pump is being used by my daughter for a school project and it is a pain having to lug a battery around, and I want...
  4. T

    OMS Pump constant clicking

    Hi All, what would cause an OMS Pump to click constantly whilst at idle. I understand that the click is an indication of the pump operating, but this one is clicking every two to three seconds whilst idling. I can't find any fuel line leaks that would allow air into the system. is it possible to...
  5. T

    Blown fuse - or something worse?

    I know, i'm stupid but it was an honest mistake. I accidently put the pos+ on the battery neg- and the neg- on the battery pos+, but it was dark and I was tired. I couldn't figure out why up on the trim was going down and vise versa, and then I realised what I had done. Changed them around the...
  6. T

    temperature gauge sender location

    I want to install a temperature gauge in my boat and I need to know where the temperature gauge sender goes into the block. I have an OMC temperature gauge and and I also need to know the part number for the sender. It is a 1994 115hp Johnson mod no. BJ115TLERC. Just to confirm, I don't want the...
  7. T

    temp gauge sender location

    where does the temp sender screw into the block on a johnson 115hp 1994 model, and does anyone know the part number for same.
  8. T

    omc temperature gauge?

    did omc make a temperature gauge to fit johnson/evinrude outboards. I have a 94 115hp Johnson and the black gauges with white writing and red/orange needles and i would like to get a matching temp gauge if they made one. if not i have an aftermarket one but i would like ome if available
  9. T

    Johnson 115hp steering

    Hey, everybody first post so here i go. I have just installed a Johnson 115hp 1994 on my boat and need to know if there is a steering tension device located on the motor, as it is very stiff to turn, my 90hp that came off the boat was very easy to turn so i know it is not the steering at fault...
Top