Search results

  1. D

    Kill switch diagram

    I understand that there are 2 different wiring diagrams for kill switcrh. t1 for 2 stroke and 1 for 4 stroke.Snyone have these
  2. D

    Replacing gauges

    I am trying to replace gauges from a 2013 nitro donor boat to a 2004 ranger. When I hook up the fuel gauge and turn on key, I get 10 volts on ground wire. Also happening when I try to hook up tach. HELP. Thank you
  3. D

    Pontoon prop help

    I have a custom 26 foot triton with a Ls1 380 hp corvette motor. I am running a bravo 3 out drive with 26 p props. My WOT RPMS is 3300.I would like to be at 5500. What prop size do I need. Thank you
  4. D

    Prop help

    Have a custom built triton with 26 inch too s. it is powered by a ls1 corvette engine with 380 hp. I have a bravo 3 out drive with 26 p props my elms are 3300 at wot. What size props should I be useing
  5. D

    Pontoon speed help

    I have a 24' smokercraft. I just added a 3rd toon with built in transom and lifting strakes.Put a 94 115 johnson motor.Have tried a 14x11 and a 14x17 prop Got plenty of hole shot but only getting about 21mph at 6000 rpm.I was getting more speed out of the 70 hp with the pwg .Any help would be...
  6. D

    powerhead rebuild

    Well I may have bitten off more than I can chew.I ended up with a 95 115 johnson that had already been disassembled.I am going to attempt to rebuild and put back together.Have had block bored and have a rebuid kit.Needing good info on bolt size and placement.Any other advice would be...
  7. D

    95 johnson 115

    I ended up with a 95 115 johnson with the power head disassembled.I have had the block bored,and ordered a powerhead rebuild kit,and a johnson factory service manual.My problem is what bolts go where.Where can I get this info.
Top