Search results

  1. kenrahe

    Tohatsu 20 HP EFI

    how many poles does my 2019 Tohatsu 20H.P. EFI outboard have I'm trying to install a Faria tach I have the tach wire at my control box but he tach says I need to set the dial on the back to a setting if anybody can tell the setting or how many poles it would be greatly appreciated
  2. kenrahe

    vinyl paint

    anyone have a link to a good vinyl paint for my seats on a 1989 cruisers 2970 esprit
  3. kenrahe

    need rudder

    Anybody know where I can get a rudder for a 1988 cruisers 2970 esprit please send a link
  4. kenrahe

    omc cobra tilt trim line leak

    Found a leak in one of my lines whats the easiest way to replace or fix the line it looks like there is no way to get to the line from inside the engine compartment at the manifold side.... The leak is at a spot that i can get to can i cut an put in a fitting an if so what kind should i use.it...
  5. kenrahe

    spark on 57 18hp model fd 11

    :confused: had spark went away like i said in post about fuel line problem motor was given to me does turn over and popped when tried to start going to pull flywheel today to look at coils and points anything i should look closely at and what should all settings be at, points,coils any help will...
  6. kenrahe

    fuel problem 57 johnston 18

    :confused:got a 57 and it looks like the person before tried to do something with the fuel line i can tell where the one to the filter goes to the fitting but it looks like there are two brass fittings on the motor for lines i'm not sure which one connects to the fitting to send pressure to the...
  7. kenrahe

    bennett trim tab help

    when i operate my trim tabs my volt meter goes way down and my motor backkfires thru my carb. what could this be and what could i check
  8. kenrahe

    bennett trim tab problem

    when i operate my trim tabs my volt meter goes way down and my motor backkfires thru my carb. what could this be and what could i check
  9. kenrahe

    2004 9.9 mercury half power

    i checked compression have 120 psi in both cylinders top cylinder fired for a little bit after compression check then quit again is this a carburator problem
  10. kenrahe

    2004 mercury 9.9 top cylinder not firing

    i have spark and good compression but it's only running on bottom cylinder put in new plugs. stillnot firing i put my finger over hole and get gas what could it be
  11. kenrahe

    2004 9.9 smokes more than normal

    when i recently ran my 2004 9.9 on the ear to flush the salt water out i noticed that i'm getting a grayish oil comming out with the exhaust do i have a seal leak somewhere.is it gear oil getting into the exhaust somehow. don't notice any water in the lower unit when i checked the drain screw......
  12. kenrahe

    2004 9.9 smokes more than normal

    when i recently ran my 2004 9.9 on the ear to flush the salt water out i noticed that i'm getting a grayish oil comming out with the exhaust do i have a seal leak somewhere.is it gear oil getting into the exhaust somehow. don't notice any water in the lower unit when i checked the drain screw......
Top