Search results

  1. I

    part name and function

    have 1972-73 130hp. Chrysler ,on top of the Distr. there is a bent bar with two screws holding it down with an electrical part above it what function does this have and the correct setting and the name of these parts .also i did a carb a link sync. motor seems to run fine but when i shift into...
  2. I

    angle of floats

    what would the float angle look like after the adj. with the carbs right side up if thats any judge would they be angled down alot of slightly just trying to get a sight on what it would look like after adj. IKE1952 this is giving me a better understanding on how things work so thanks for your exp.
  3. I

    angle of floats

    when you say you adj. slightly down , what would the angle of the floats look like if you turn the carb.. right side up after adj. IKE1952 130hp. dual carbs 1973 Chrysler .would the float be angled down at a sharp angle or a slight angle thank you this helped alot the way i,m getting this is...
  4. I

    float adj. for a 130hp. 1973 Chrysler outboard

    i have a 130hp. 1973 Chrysler outboard what are the tools i need to do a float adj. ,and where do i measure from when adj. the floats .i know the tab adj. when you push it in it comes up closer to the carb i would like to do this right the first time because of the bolts that hold the fuel bowls...
  5. I

    1973 130hp. Chrysler out board

    i have a what i think is a 130hp. Chrysler outboard ,my ? is is the rotor button removable .this is a Distr. without points i guess you would call it an ignition module or Breakerless not sure ,but like my ? asked is the rotor button removable and how is this done ,or should i just clean it...
  6. I

    chrysler 130hp.how to read timimg marks ,spark plug gap and point gap

    does anyone know these gaps for spark plugs and point gap, and timimg mark settings how are the timing marks set up as far as reading the gage on the flywheel..
Top