Search results

  1. M

    Motorguide Brute Overhaul?

    I have a 50 Lb. thrust 12/24 volt motorguide brute trolling motor that has lost power over the last couple of years. It still spins good but slows down under load. Has anybody had any luck rebuilding them? I was thinking new brushes, o-rings, bushings, etc.. and having the armature turned. Let...
  2. M

    Evinrude V6 Rectifier interchange

    I have a 92 Evinrude 150 HP 60 degree V6 with a bad rectifier (part no. 584093). I have a rectifier off a later model Ocean Pro 150 HP(part no. 586048) that looks like it should work. Can anybody verify this before I do something stupid?
  3. M

    Checking Rectifier Diodes

    1992 Evinrude 150 HP 60 Degree V6<br />I am almost sure my rectifier has gone bad (tach quit working, battery not charging) but before I trash it I would like to check the internal diodes. The stator checked out okay according to resistance readings per my manual, but my manual is unclear on the...
  4. M

    pressure test block for water leak - how?

    I have 92 evinrude 150 hp 60 degree v6 motor with a suspected water leak in the no. 1 cylinder. Dhadley said that a pressure test could be done to confirm. Just curious - What is involved in such a test? any special equipment required? how do you plug the holes? approx. cost or hours if dealer...
  5. M

    evinrude v6 #1 cyl. water leak

    I have read on this forum about the casting seam water leak into the no. 1 cylinder inherit in the Evinrude and Johnson 150 HP 60 degree V6 motors. I suspect my 92 Evinrude 150 may have this problem. The no. 1 plug and top of piston are clean compared to the other 5, although compression on all...
Top