Search results

  1. J

    2003 Glastron SX 170 Windshield

    Hello, anyone know where I can find a new or used windshield (and frame , Drivers side) for a 2003 Glastron SX 170. thanks, Jumbo
  2. J

    2003 Glastron sx170

    I was wondering if anyone with a 2003 Glastron sx170 has an issue with water consistently pooling in the carpeting of the lower mid section storage unit ( wake board storage??). It seems when at rest this is the low point of the hull so any water in the boat tends to soak onto the carpet and...
  3. J

    1983 Suzuki DT115 Rebuild

    Looking into the possibility of doing a top cylinder Piston replacement on an 1983 DT115. Does anyone know where I can find a service manual and/or parts to do this rebuild. thanks,
  4. J

    1987 mercury exhaust question

    60 hp Mercury, on the two exhaust ports just below the powerhead in the mid section should there be water coming from these ports as well as exhaust gases. If there is water where is it likely coming from, In the exhaust plate or from the powerhead. thanks for any help jumbo3905
  5. J

    1987 60 HP water leak from lower powerhead and chokes with the cover on

    I have a rebuilt 1987 60 HP, did a full lync and sync and it runs perfectly with the cover off but chokes on acceleration when the cover is installed. Also have a small amount of water spitting from the Power head lower gasket. I did do an impeller replacement as well so the lower unit has been...
  6. J

    1987 mercury 60 hp piston damage

    Hello, I had a piston failure in my number 1 cylinder and I was wondering if anyone might be able to identify the root cause from seeing the piston. The engine did not seize but the metal pushed onto the plug shorted the spark killing the one cylinder. I recently had to replace the stator and...
  7. J

    1995 9.9 hp fourstroke oil leak

    I have a 1995 9.9 hp Johnson 4 stroke and it spits oil from the tube that runs on top of the carburetor from the cylinder head cover at the rear. Does anyone have any ideas why it would be doing this ? There may be a possible leak in the lower power head seal would it cause some kind of...
  8. J

    1995 9.9 Johnson 4 stroke spitting oil

    Hello, I have a 9.9 hp Johnson 4 stroke and it spits oil from the tube that runs a top the carburetor from the cylinder head cover at the rear. Does anyone have any ideas why it would be doing this ? thanks, Dan
  9. J

    1987 Mercury 60 hp Waterpump question

    Hello, The waterpump housing on my 1987 60 hp has a factory "cut out" in the output, does the rubber seal between the housing and the water pipe fit on the inside of the water pump housing? the exploded view doesn't show this clearly, it also shows a Nylon washer in the housing output does the...
  10. J

    1987 Mercury 60 hp Service manual

    Does anyone have a PDF file of the service manual for this motor. Specifically looking for the snyc and link procedure but the entire pdf manual would be great. thanks
  11. J

    who makes Mercury WM carbs and welch plugs

    Who makes the WM model carb on a 1987 Mercury 60 hp and where can I buy just the Welch plugs for the carb.
  12. J

    1987 Mercury 60 hp carb leaking

    I have a 1987 Mercury 60 hp that whenever I trim it up the carburetor's leak fuel out the front of the carb throat. This is a 3 cyl 2 carb set up and the lower carb really spills out the gas/oil mixture. This is when the engine is off and the motor is trimmed up. The fuel appears to come through...
Top