Search results

  1. B

    starter issue and ?

    I have an 83 Johnson 35hp long shaft j35elects. I was boating the other day turned sharp and it stalled. It then would not refire. I know that the starter is going bad for it needs tapped on here and there so I am going to change it and use a rebuild kit on the carb while I have it off hoping...
  2. B

    bought a different lower unit for my 83 johnson long shaft, not fitting

    i have an 83 johnson 35hp j35elcts i purchased a lower unit i was told would fit on ebay said 20 25 35 lower unit. it was a short shaft so i swapped shafts. it seems that the top of the driveshaft is the whole way up and bottom whole way down but roughly 1.5 inches from fitting snug is there a...
  3. B

    no engine kill switch JOHNSON

    had my lower unit go bad in my 1983 johnson 35hp j35elcts so I purchased a 1986 28 hp J28ELCDS. Used the controls I had got everything plugged in. Only problem when I shut the key off engine still runs. What can I do besides run a separate kill switch from the magneto. Thank you
  4. B

    Johnson lower runit

    i have a johnson 1983 35hp long shaft j35elcts. I need a lower unit the part number is 0392539 and is the same for 83-84. I see a lot online that say they fit 76-92 and such. Can anyone help me on which year and what hp will also work. Thank you
  5. B

    What lower units fit a Johnson 1983 35hp J35elects

    found a 1985 Johnson 30hp lower unit would it fit ?
  6. B

    80s Johnson 35 hp lower unit

    model number j35elcts serial number f5801075 Trying to remove the lower unit. Everything is undone except the top of the shifter rod. How do I undo it. Any one have pictures ? I have something sheared I believe. Starts and runs but feels like a tooth missing on something when in forward...
  7. B

    1980s JOHNSON 35hp taking lower unit off

    took the permanant bolts off my lower until, it lowers a bit, and a little more when in reverse. can not get it to drop down more than roughly a half inch. is there a pin or something you need to remove. i do not see one. It starts good, goes into reverse well and neutral something clunking...
  8. B

    Evinrude 6704m

    Evinrude 6hp 1977. got it about ready to go, only prob when I start it vibrates of instead of an idle, I have to hold it. Thinking possibly need a new spring and also curios where and how about would I check and adjust linkage. Do they maybe make a tiller grip that fits with the locking...
  9. B

    evinrude 6hp Shfting issue

    model 6704 1977. When starting the motor only stop clicks on the throttle, seems to be play through start, shift, and slow. Have to hold on fast when starting to have an idle. Good compression, revs well, adjusted the lean and rich (where should it be set) What could this be ?
  10. B

    evinrude model 6704 1977 6hp pull rope

    pull rope is broke, has the spindle design, how does one go about installing new pull rope. thank you
  11. B

    Sears 3.5 need fuel connector

    on the tag there is Model # 60920 then under it 09650568B although Ive read this is the engine tag. I cant find the serial number. I need the fuel connector that hooks to the outboard from the fuel line. Where would I find part or info for this ? The 1st picture is the item I need, others...
Top