Search results

  1. F

    Retrieving information out of PCM

    Hey guys, i have just purchased a 2014 150 opti from a dealer and want to know how i can retrieve the information of how many hours etc had been done on this engine. Do you need certain scan tools? Reason i am asking is the place i have purchased from may have swapped the engine i looked at in...
  2. F

    Gearbox clunking

    Hey guys, I have recently done some changes to engine and put a new controller in. I had to adjust shift and throttle cables. Gone by the book and pretty sure i got it right, but now i have a clunk clunk clunk noise after it is in gear and just off idle, as soon as a rev up a bit more its gone...
  3. F

    Possible faulty TPS?

    So i was setting up my TPS and the voltage required at closed throttle is .24-.26 volts. My tps only goes as low as this. I get it about 1/3 of the way back and from there to total closed its the same voltage. It goes up to correct place on WOT but doesnt change at lower end to lower voltage...
  4. F

    1997 Mariner 150HP Magnum EFI surging

    Hey guys, Right i have a problem here. At 3,000 rpm engine seems to be fine but as soon as i go over this and get up around 4000 rpm the engine starts surging. Was out in it today and it was doing it at 3100 rpm and after i got to location and left again it ran fine, then started to slowly do...
  5. F

    96 Mariner 150 EFI running on 4 cyl's

    Hey so like the topic says mine is running on 4 cyls. Ive had it looked at by a boat mechanic and they have gone through the ignition side of things saying that is ok. They told me number 1 and 4 werent getting fuel. So i pulled the injectors out and had them tested, in which they were cleaned...
  6. F

    1996 Mariner 150 Magnum

    Anyone know where i could find a repair manual for this engine?
  7. F

    Decals for Suzuki DT 85

    Hey guys, Not sure if this has been discussed on here but im respraying my 1985 Suzuki DT 85 and for the life of me can't find anyone who sells the decals for the whole engine. Any help is much appreciated. And i have been to brownspoint but the are no longer available apparently.
Top