Search results

  1. S

    Holley 2300 2 BBL fuel filter

    Is there a fuel filter in 2300 Holley carb.?
  2. S

    Carb. runs dry.

    My 2008 4.3 GL-J carb. looses its prime after 2 weeks sitting. Is the bowl draining for some reason. I have to squirt wd40 in carb and it cranks right up. I never hear the fuel pump run when I turn on the ignition. The choke works fine. It will crank right up the rest of the day. Its a Holly...
  3. S

    2008 4.3GL Distributor Hold-Down Screw

    What tool does it take to loosen the distributor hold- down screw. Some kind of tamper resistant screw.
  4. S

    4.3 Gl over heat

    My 2008 4.3gl will over heat at 3000 rpm but runs fine normal at 3500 rpm and up. Cool at idle too. What's happening?
  5. S

    2006 Bennington 2275RL listing to left

    My 22 ft. Bennington 2275RL has always listed to the left. I bought it new and it has always done this. Even sitting still you can tell it is leaning to left. The dealer says because fuel tank is on the lft rear corner. It still does this with no fuel in tank. The motor is a Yamaha F150. It is...
  6. S

    SX shifting

    My 1995 SX drive doesnt want go into reverse sometimes. When you put in reverse it takes about 5 seconds for it to go into reverse. It always goes into forward gear right away. It is nothing to do with the cables, they are good. Something going on in the drive. It has new Mobile synthetic oil in...
  7. S

    4.3 L carb question

    I have a 1995 18 ft runabout with the 4.3 GL. I just put a factory 4 bbl. intake and a new Holley marine 600 carb for this engine. I gained about 3 mph on top end but when accelerating for a dead stop with full throttle it does not want to take off very good. Is there a secondary adjustment I...
  8. S

    SX Gimbal Bearing install

    I am replacing the gimbal bearing in my 1995 SX drive. Does it matter which way you install the notches in the bearing into the housing? Thanks, Mark
  9. S

    4.3L 4 BBL intake

    Hello all. I have a 1995 4.3L 2 bbl Holley. I want to put a 4 BBL intake and carb on it. It has the 12 bolt manifold with the balance shaft. Will an aftermarket intake from Edelbrock work with the balance shaft. Thanks for the info.
Top