Search results

  1. J

    Motor Mounting Pin Adjustment

    I was wondering if there is an optimal position to lock the motor with the pin that changes the angle when trim is down. Mine was set to the top hole (leg closest to the transom when lowered) when i bought it. By moving this pin to one of the other 5 holes, what will that do to my performance...
  2. J

    1982 80hp MARINER bogging between low and high rpm

    My issues aren't quite over. I have a bogging and sputtering occurring, that i think is flooding, at lower RPM's before the motor will accept the fuel for WOT. If i nurse it with the choke button on the key, rpms will increase gradually until i can throttle up with the lever. I just redid a...
  3. J

    1982 80hp mariner fixed; linkage question

    Thank you everyone for all your help with getting that Mariner of mine going. I got very good response out of the motor on the water. However, the first 30 seconds or so after starting (like a dream!!), the motor doesn't want to take the small increments of fuel as i increase throttle. After it...
  4. J

    80 hp checking coils and reeds while dismantled

    I have taken most of the housing brackets, starter, solenoid and carb plates off of my 80hp mariner to replace some electrical components. Is it possible to bench test the coils and is there a way to confirm whether or not the reeds are working by pulling the plugs and cranking over by hand? i...
  5. J

    1979-80 80 hp 4 cyl Mariner

    Can't get motor to start or idle. Lots of crank on spiral grid battery. Did not run at all last year, but used to idle nicely when warm and lots of top end. Had trouble keeping it running in between idle and full throttle. Rebuilt carbs last year, adjusted idle lever up a bit. Top carb now dumps...
Top