What is the proper procedure to troubleshoot a suspected failing starter while on the motor? Are there voltages i can check?
The starter motor will work "normally" sometimes and other times will be so sluggish it cant start the motor. Same battery
Thanks in advance for any help.
Can this type of fuel pump be rebuilt or do i have to buy a complete pump?
If i can rebuild it where is the place to get parts?
Thanks in advance for any help in the matter.
Need help on this one.
THANKS IN ADVANCE WITH ANY HELP!
1969 55hp Evinrude 3 cyl. on a 1969 Bomber Bass Boat
Helping a friend out.
On the lake fishing 2 months ago motor just quit heading back to boat ramp.
Would not re-start killed battery trying.
Diagnosed no spark.
Dist. Cap and Rotor were...
1969 EVINRUDE 55 HP
I replaced original amp with new CDI amp that has no tach support. They say to connect tach wire to yellow stator wire.
I have NOS tach that supports 12p and it does not move the needle when running.
Tested rectifier and showed bad.
The question is if I disconnect the...
Anybody have a good way of removing these so they are re-usable?
I am going to give the carbs a chem dip and need to take the plastic off.
Thanks for the help in advance.
Should water be coming out here under normal operating temperature?
I didn?t see a drop when on muffs or on the lake.
Thanks for any help in advance.
Evinrude Model #55973
I am looking for a 12p external tachometer due to the lack of room on the dash.
Anyone have a suggestions?
Most of the external tachs I see do not support 12p.
Thanks for help in advance.
1969 Evinrude 55hp
I would like to do some maintenance on this tilt pump due to it struggling at the bottom end.
I have the service manual for the motor but it does not show the pump.
Was it an option with the motor or is it a after market add-on.
What oil do I use? What is the correct procedure...
What is the best roller, bow stop and winch setup for this combo?
I would like a 12 self centering keel roller at the back.
I don't like the bow stop below the winch strap, makes it hard to secure.
Any ideas would be appreciated.
I need to rebuild the carb on 1964 Johnson MQ.
I have the owners manual but is does not have any info to remove the carb.
Do I have to remove the fly wheel to remove the carb?
Any info would be appreciated.