Search results

  1. D

    force tourque values not in book

    i have a 1989 force 150, the values for the reed assembly and intake manifolds not in book it said see table 4 but they are not there i have the clymers manual please help if you can...<br /><br />dave
  2. D

    force 150 gas

    i need to get the old gas out of a 140 gallon tank on my bayliner trophy, anything i can do to clean the tank out so i know there is no debre in there?<br />its buried in the hull
  3. D

    porblem removing lower unit force 150 1989

    i have read it is easier to install the powerhead if you remove the lower unit firts, im installing new impeller anyway, problem boat is at marina up on blocks, ground is to close to get lower unit off, cant use the trim because all the wires are disconnected from the whole powerhead, any ideas...
  4. D

    finally getting powerhead back from machine shop

    force 150 1989<br /><br />other then the head gasket, are there any other gaskets that should not receive the gasket sealing compound, exhaust ports, carbs, reed valve assembily,fuel recirculation....ect
  5. D

    which carb kit do i need

    i have a 1989 150 force, <br />number on block 1501x98<br />&<br />n606463<br /><br />do i need a rebuild kit for tillotson or walbro type carb
  6. D

    1989 force cylinder sleeves or not

    machine shop has powerhead and is going to look at the cylinders, do these get hones or bored, or are they replaceable?
  7. D

    type of carb on my force 150 1989

    how can i tell which carb rebuild kit to get, no marking on the carbs i can find. I guess there are two types of carbs available?
  8. D

    prep powerhead for macnine shop

    150 hp force rebuilding, im cleaning all gasket materials and all the carbon i can see without splitting the crank case, is there anything else i should do before i send to the machine shop, they will do any machineing and install bearings and pistons and all.
  9. D

    rebuilding powerhead force 150 stuck spacer plate

    the manual said there are four nuts holding on the spacer plate that goes between the powerhead and the lower unit. Manual said not to remove exaust tube unless replacing. There are five nuts. One is closest to exaust port very rusted and damaged. All other bolts look good. Is this extra nut...
  10. D

    powerheadkit.com

    has anybody done business with these guys, they also have great prices on rebuilt head. Just trying to make sure they are a reputable company befor i packup and ship them my powerhead :rolleyes:
  11. D

    150 force powerhead replacement

    buying rebuilt powerhead, just about ready to remove head, have a manusl, any headsup to worry about befor i hook up the cherrypicker, seems driveshaft and crank should be connected but not really desctibed in manual. any tips on instalation?
Top