Search results

  1. M

    wet epoxy?

    I have a 16' aluminum Lund. I believe that the floation under the floor has absorbed salt water, and is causing corrosion. I realize that the floor must come up & all water soaked material removed & replaced. As a temp. fix does anyone know of an epoxy, or 5200 type material that can be applied...
  2. M

    acts like a slipping clutch

    Have a 1977 25hp Johnson mod#25E77S. While running slow if I crack the gas wide open the motor revs, & it don't go. My first thought was broken shear pin, pulled the prop, & all is good. If I give it the gas slow & steady, all is good, boat gets up on plane with no problem. If I give it the gas...
  3. M

    Spark Plug Gap

    Where can I find the correct spark plug gap for a 1977 Johnson Mod#25E77S Thanks, John
  4. M

    SKEG REPAIR

    I was smart enough to find a rock with my 1995 30hp evinrude, & broke 3" off the skeg, I have the broken piece. I was considering having it welded, but I'm concerned about the heat from the process, on the gearcase. THOUGHTS? JOHN
  5. M

    30 HP evinrude water pump

    Getting ready to replace the water pump in my 1996 30 hp evinrude E30TEEDE. I'll get the water pump kit. Doesn't look like the complete water pump is available, or is it? At present no leeks in the lower unit. My question is, I guess there is a gasket between the gear case & the lower unit...
  6. M

    Frest water flush

    It was suggested on another site, to add a little dishwashing soap to the fauset end of the hose when flushing an outboard that has been used in saltwater. My outboard is a 1996 30HP evinrude, lots & lots of hours, used in saltwater, ALWAYS flushed after every use. Still the original water pump...
  7. M

    More hp

    I have a 1996 30 HP evinrude Mod#E30TEEDE, this is an electric start, tiller unit. VERY happy with it, & it has proven to be a dependable work horse after many hours of use. Is there a way to get a few more HP from this motor without major changes? In no way do I want to compromise how...
  8. M

    Hour meter

    I have a 1996 30HP evinrude, mod#E30TEEDE. Is there any way to hook up an hour meter to this motor? A small meter that would fit inside the cover? THANKS, JOHN
  9. M

    Champion or ngk plugs

    FIRST hello to all, new to iboats. I have a 1996 30 hp evinrude, tiller, electric start, model E30TEEDE since it was new. While talking with an outboard tech. he advised against using NGK spark plugs in the smaller two strokes, because they burn too hot & could cause piston damage. The "book"...
Top