Search results

  1. C

    Help diagnosing electrical issue. 1998 Yamaha 90hp B90TLRW

    I'm reposting this is the proper forum. Any help would be greatly appreciated. http://forums.iboats.com/forum/boat-repair-and-restoration/electrical-electronics-audio-and-trolling-motors/9998382-1998-b90tlrw-electrical-help-coil-packs-cdi Thanks!
  2. C

    1998 B90TLRW Electrical Help (Coil packs/CDI)

    I just rebuilt this motor and it idles well on the muffs. I went to take it out today to break it in and found that it has no power once it is put into forward or reverse. I took it home and put it back on the muffs, I started the motor and the pulled the plug off of the #3 cylinder. The...
  3. C

    1998 B90TLRW Starting Help

    I got this motor from a gentleman for $500, he stated it was bad and worthless. I took it all apart, had the block ported and honed and installed new pistons, bearings, etc... I basically rebuilt the entire powerhead. I have installed all of the components, however I am not getting any...
  4. C

    Help installing a tach on 99' Yamaha 60hp 2-stroke

    Can anyone help me with an installation of a tach on my motor? Like which wires to splice,etc? Any help is appreciated. Thanks!
  5. C

    Need help with gauges and installation

    I just purchased a 1999 60hp yamaha outboard. The previous owner only had a fuel gauge installed. It is not functioning and I'd like to purchase the following gauges and install them: Fuel Temperature RPM Tilt/Trim The fuel gauge I can figure out, since it's already installed. But...
  6. C

    Help with resealing my crankcase, 35hp 35E77C 1977

    I rebuilt the power head about 10 months ago. It has been working great, however I was running on a plane a few weeks ago and lost all power. It would only idle and that's it. I took the cover off and saw that fuel was leaking and coming from between the two halves of the crankcase. I have...
  7. C

    99' 60hp Yamaha help - Purchasing a boat with this motor and trying to do my homework

    I am looking to purchase a 99' Polar and it comes with a 99' Yamahan 60hp 2-stroke. I did a water test with the owner on Saturday and it ran very good. The owner said that he hasn't had any real trouble with it except that he does have to frequently take the carbs off and clean them becuase he...
  8. C

    How to wire an overheat buzzer on 1977 35hp (35e77c)

    I have a 77' 35hp that I have installed a temp gauge on. Just one of the ones that touch the head and send a signal to the gauge. I would also like to wire in a buzzer that will give me an audible alarm if things begin to go south. It would be great to be able to set the temp at which for it to...
  9. C

    Looking to paint my boat, what paint should I use? Opinions welcome. ;)

    I have an old 1978 Lake Flight Plastics Tri-Hull that I would like to paint the inside of. What brand/type of paint should I use?
  10. C

    Johnson 48

    I'm looking to purchase a 1984 Carolina Skiff, it has a Johnson 48 on it. Someone painted the bottom of the boat, and included the foot of the motor as well... :-\ But besides that, I'm wondering if anyone can tell me a little about the motor. I just rebuilt my 35hp Johnson and it's doing...
  11. C

    Where can I find new controls?

    I have a 35hp that I just rebuilt and reinstalled. My throttle cable has been on the fringe for a while and when I was reinstalling it, it snapped in two. So where can I find a replacement cable? And about how much do they run? Thanks in advance for your help. I need to figure this out soon...
  12. C

    Anyone know minimum cylinder head measurement for 1977 35hp?

    I'm taking my head in tomorrow to see if it can be decked. Does anyone know the minimum head thickness or know where to find it? My Clymer shop manual doesn't list it. It has been decked once, so I'm hoping I can get away with another.
  13. C

    Newbie Here, Need some engine help... Please... 77' Johnson 35hp

    Good afternoon, I'm having trouble with my motor. I bought the boat used from a friend. He told me that he had rebuilt the entire motor, pistons, rings, rods, etc... I took the boat out 5-6 times with no trouble at all. Last weekend I went out with my son and the motor overheated. We were...
Top