Search results

  1. S

    Parts for sale

    Can you list parts for sale on iboats? If so how would one go about it?
  2. S

    B/W transmission shifting??

    I have an older B/W transmission that I have never used. While on the bench if you turn the input shaft the output coupler goes in the same direction regardless of the placement of the shift lever. It is a 1:1 AS1-71C. Thanks
  3. S

    1978 evinrude 15 hp cooling

    Is the telltale water discharge the only water discharge on the rude 15 or is there another discharge below the water line? Thanks in advance. Chuck
  4. S

    1978 Evinrude 15 hp pull cord and spark plug questions.

    Just broke the pull cord on above engine. Info on how to replace it would be greatly appreciated. Also on a couple of smaller Rudes that I have gotten the bottom spark plug seems to be discolored like a brassy look to it and the top one looks as it should. Is this a sign of overheating ? I have...
  5. S

    1965 evinrude 6 hp compression?

    Looking at getting a Rude 6hp/1965. Owner says it has 90 lbs compression on both cyls. Is this good? What is normal for this engine? Thanks in advance.
  6. S

    1968 Evinrude 3 hp cooling

    Should the 3 hp Rude have a tell tale? Also I am replacing the impeller and there is a round plate just below the impeller. It has a crescent shot on it and I cannot remember if the slot went to the front or back or does it even matter. Thanks crew!
  7. S

    1968 3hp Evinrude folding shaft fuel pump

    Hello. I got anew fuel pump for my little Evinrude 1968 3hp however when I tried to install it the long mounting bolts do not line up. If I try to turn it 90 degrees to make the long bolts line up it doesn't look right and will bend the fuel lines too much. I thought of switching the bolts but...
  8. S

    1978 Evinrude 15 hp cooling question

    Does a 1978 Evinrude 15 hp engine have a water discharge above the water line and under the cowling? Thanks
  9. S

    Decarbonizing engine

    Correct me if I am wrong but it seems that to "decarbonize" an engine you need to mix one can of Seafoam to 1 gallon of fuel? I know this sounds like a dumb question but..I'm assuming that you use mixed fuel (oil and gas) to decarbonize 2 cycle engines.
  10. S

    1971 Glassmaster 15+ ft 85 hp Evinrude

    Picked up this G'master on Ebay for $700. Interior,seats, conv top, trailer, etc in very good cond. Owner stated that the boat was last started 21 yrs ago when put in storage. Has never been kept outside. I figured the hull and trailer were worth that alone as I love the Old Glassmaster , tri...
  11. S

    Evinrude 85 hp 1974 thermostat question

    Recently purchased a 1974 evinrude 85 hp. Was able to get it running but noticed that no water was coming out of the back holes of the motor. I ordered a new impeller kit but was wondering if a bad thermostat also could cause the motor to not be able to let water out the discharge? Are they...
  12. S

    rpm question, evinrude lark III

    Can someone tell me the standard rpm of an Evinrude LarkIII 1961 40 hp? Thanks
Top