Search results

  1. TimeZone

    Quick Question / Gimbal Ring Height Adjustment ?

    I'm trying to chase down a vibration from my drive. vibration is most noticeable at fast idle up to about 1500 RPM Noticeable both in gear and in neutral Changes slightly with trim Increases when steering is near full lock Not noticeable at 3000 RPM to WOT which is perfect at 4800 RPM and 50...
  2. TimeZone

    Heavy Steering - after fluid flush

    Power steering was working well last weekend although the fluid was black in color. Did a complete fluid flush during the week and bled the system. Used OEM Mercruiser power steering & Trim fluid. The problem is when I turn the wheel quickly from lock to lock I get full power assist. But...
  3. TimeZone

    Idle Mixture Adjustmen - Location?

    Quick question guys... Can anyone tell me where the idle mixture screw is located? (Not idle speed) I've looked all over and can't seem to spot it. 2005, 4.3, 2 barrel Carb Ser # OW328841 Thanks in advance! Ron
  4. TimeZone

    How To - Power Steering Flush

    Any suggestions or procedures on doing a power steering flush? I was bleeding the system and noticed the fluid is dark and since I don't really know the history of this boat...I want to do a complete drain and refill. I can wing it, but I'm thinking there might be a 'best practice' to make...
  5. TimeZone

    Quick Rear Engine Mount Question

    Pulled the engine last night to replace the coupler. Expecting to find double wound lock washers on the rear mounts but found flat washers instead.:confused: I found some mention of flat washers in some threads in this forum, but no clear explanation. Is it OK to put back with washers or...
  6. TimeZone

    Coupler - Not Centered

    Need some advice on my engine coupler. Can't find any specification in the service manual and reading through the engine alignment thread, there is no real limit on "centered and true". So...Doing an engine alignment and got the spline/grease marks looking perfect on the alignment tool. The...
  7. TimeZone

    Grease Seal Removal

    Pulled the gimbal bearing out today and decided to replace the grease seal as well. Is there a trick to getting this thing out? I tried the slide hammer but it just slips off the soft rubber. There is a notch at the bottom of the housing that seems to go right through to the back side of the...
Top