Search results

  1. D

    Johnson 150 Idle Problems

    I have idle problems with my 2003 150, and I'm having trouble finding a solution. The difficulties arise when lowering the speed to idle in gear or out of gear. With the idle speed set at 750 or below, the idle speed will gradually lower until about 500 rpm where the engine will kill. This takes...
  2. D

    150 Johnson Timing

    What idle and WOT timing spec for a 2003 150 Johnson? Do you need a special OMC tool, or can an automotive inductive type timing light be used?
  3. D

    Possible Damage?

    Well, I may have done something very stupid. Today I decided to clean and lubricate the cables, linkage, steering and tilt points. Without thinking, I moved the throttle control through the foward and reverse positions and to WOT. The stupid part is the shifting was done without the OB running...
  4. D

    150 Johnson Gear Lube Capacity

    What is the gear lube capacity for a 2003 150 Johnson? My dealer sold me a 1 quart kit and said it was enough, but I bought a second just to be sure. <br /><br />I filled the gearcase from the bottom screw and filled until the lube dripped from the top, which amounted to 45 oz. Is this correct?
  5. D

    HELP 150 Johnson Problems

    I have a 2003 150 Johnson that I'm fighting with a idle speed and cruise speed fluctuation after taking it to dealer for service. It was brought for service because the engine would kill when engaging reverse from idle; only reverse not foward.<br /><br />Well, I took it to the dealer who simply...
  6. D

    Two Cycle Oil

    Why and how are two cycles different for air and water cooled engines?
  7. D

    V-6 Johnson

    What is the factory specification idle speed for a 2003 150hp Johnson?<br /><br />Thanks!
  8. D

    150 Johnson stalls in Reverse

    What could cause the OB to stall in reverse, but not foward. Sometimes, if I'm very fast and lucky, I can quckly move the throttle to mid position and kept the OB from stalling. However, this is not practical or safe in most situations, and I'm worried this may damage the lower unit. Please help.
  9. D

    150 Johnson Idle Speed

    How is the idle speed adjusted on a 2003 150 Johnson? I'd like to increase the idle speed 100 rpm.<br /><br />Thanks!
  10. D

    Prop Nut Torque

    What is the correct torque spec for a 2003 150 Johnson prop?
  11. D

    2003 Johnson 150 Engine Speed ?

    What WOT engine speed should I be aiming for when selecting a prop pitch?<br /><br />I currently have a Viper 14-3/4" x 19" on a <br />Cape Horn 17 with a WOT engine speed of 5000 rpm. I was expecting 5500 rpm. I checked the throttle linkage, and the carb blades are fully open at maximum...
  12. D

    Johnson 150 Bulb

    Is it possible to hydraulic lock a OB with the fuel bulb while runing? <br /><br />Yesterday, while running at 2500 rpm, it felt like the prop hit something in the water. I turned to see what happen, and my son was in the back pumping the fuel bulb. I stopped lifted the motor to check for damage...
  13. D

    Gear Lube

    What is the absolute best gear lube to use in the V-6 gear case?
  14. D

    Primer Bulb Location

    Where should the primer bulb be located; between the tank and filter or between the filter and outboard? This for a 150 Johnson with carbs.<br />Thanks!
  15. D

    Cape Horn Liner

    I have a new 2004 Cape Horn 17, and the floor is uneven. Using a 2x4, that I know to be straight, and laying the board along the length of the interior, there is depression forward of the scuppers that is 3/4" deep on the port side and 1/2" on the starboard side. This allows water to pond in...
  16. D

    Oil Selection

    Anyone run the Ficht ram oil or the Mercury Premium Plus in a Johnson 150? Any advantage over the XD25 in terms of longevity, smoke or carbon build up?
  17. D

    Primer Bulb

    Should the primer bulb bleed down with the engine off? This past weekend, I had the engine off for approximately 10 minutes, and bulb had to be pumped backup before the it would start. Is this an indication of a problem with bulb or air entering the fuel line between the tank and the bulb or...
  18. D

    Propeller 4 or 5 blade

    I have a 150 Johnson on a Cape Horn boat, and I have a little problem with ventilation while turning. The ventilation plate is 1" above the bottom of keel and cannot be lowered further. I have a 19" pitch Viper prop now. Will a four or five blade prop help this situation? Would a change in pitch...
  19. D

    Fire Extinguisher

    What are the guidelines and USCG requirements for the location of the fire extinguisher? Can it be mounted in a closed compartment?
  20. D

    Fire Extinguisher

    What are the guidelines and USCG requirements for the location of the fire extinguisher? Can it be mounted in a closed compartment?
Top