Search results

  1. P

    68 evinrude 6hp dire need of help..

    Model - 6082C New: Coils Condensors Points set at .20 Plug wires Plugs (good spark both cylinders) gaped at .30 Fuel pump Fuel lines Good compression both cylinders New carb kit Impeller Gear oil My problem: Starts and idles perfect in a couple pulls Can get half throttle fine, once i get past...
  2. P

    Eska 7.5 float level issue

    Trying to get the float level set to the spec height. I know the proper height and the bend the tab method to set it. My problem is that i cannot get it to the spec level. The inlet needle seat is down all the way and there is no debris under it to cause the height issue.. I have the tab bent...
  3. P

    Sear ted williams 7.5 lower unit/prop?

    Model 217.58890 Replacing the impeller on it the lower unit dropped down fine.. My problem is.. I put it all back together and now when i put it into gear i have no spin on my prop. It did spin just fine prior to replacing the impeller. Ive taken it apart 3x now to make sure it line up...
  4. P

    6hp evinrude lower unit

    finally got my 6hp to turn over and run.. but it seemed to be over heating.. so i was going to check the impeller and water pump in the lower unit.. i got one bolt out.. but the other three boltss, the heads broke.. YIKES!!! after all the work i put into getting this thing started, this crap...
  5. P

    6hp evinrude spark plug wire question..

    will this work as a replacement for plug wires for a 6802c model.. original wires are discontinued.. http://www.iboats.com/Mallory-Plug-Wire-22-9-28007/dm/*******.828292573--session_id.954481580--view_id.365674
  6. P

    6 hp evinrude outboard help please

    6 hp evinrude 1968 model 6802C not getting spark on 1 lead and getting barely any spark on the other should i replace the coil pack or the leads or the condenser? dont know where to start checking why im not getting good if any spark
  7. P

    sears ted williams 7.5 HELP PLEASE

    110 commpression.. carb has been rebuilt twice... starts up.. but then dies out.. if the water pump isnt working right can it over heat and not want to start/stay running? or can it be sucking air somewhere? or rebuild the carb AGAIN? any input would help thanx
Top