Search results

  1. F

    2001 75 mercury wont even try to turn over!!!!!

    2001 75hp Tracker Mercury will not even attempt to start when the key is turned. It isn't doing nothing as if there is no power getting to the motor to start it. Ran great last year but know it wont even try to start. I charged the battery, checked the battery fuse and still not a thing. I am...
  2. F

    Question about coil packs

    I have found a ton of coil packs that are for the same year same horsepower as I have but the last numbers on the coils are different. The numbers on my coils are 582508 23DN OA and 582508 28DN OA.The numbers on the coils I have found for replacement are the same 582508 but the last numbers and...
  3. F

    15hp Evinrude is acting up!!!

    Recently converted my 15hp manual start to electric start. I made the conversion simple with no recharge. I used an electric flywheel from the same year, used the same original manual start stator and ran my positive wire from the starter to the battery with a start button in between. I ran the...
  4. F

    9.9/15hp conversion=wont plane out

    1985 Johnson model J10RC0M. I Changed the carb on this motor with a 15hp. I research and it seems that the carb is the only thing that I need to change on this motor so i did. The boat ran great with me in it. Then me and a buddy went fishing and the thing would not get up on plane. It felt like...
  5. F

    30hp Evinrude will not run????

    I have a 30hp Evinrude that I bought that is not a tiller handle motor but I am going to convert to one if I can figure this thing out first. I did not receive any throttle cables, steering cables or ignition with it so i tried to get it started by jumping the started solenoid because there is...
  6. F

    15hp sears gamefisher tiller handle issue

    My tiller handle on my 1979 sears has excessive play in it. The throttle grip shifts of center when using it to rev the motor or drop it down to idle(using it period). What could cause this. Any help is greatly appreciated. Thanks
  7. F

    I can not get this lower unit off. Any help is appreciated.

    Ok. For starters, i do understand that this is not the correct forum for my question but I'm beggining to think it might be . I posted my thread in the other outboards forum and many people viewed it but there were no responses. If anyone has a clue or if anyone can find any information on how...
  8. F

    Does anyone have any knowledge of or literature on a 9hp volvo penta?

    I have an old 9hp volvo and I need to change out the impeller. I was told in order to get the lower unit to drop you have to pull the shift rod out of the leg. The shift rod will not come out. Thanks
  9. F

    Any help on my Volvo penta 9hp lower unit removal

    I cannot get the lower unit off of this thing. Once the bolts are out, the lower unit drops down but it will not come apart. If you can find any information on how to or you know how to remove the lower unit, the knowledge is greatly appreciated.
  10. F

    30hp Mariner lower unit

    I have a 1986 30hp mariner that needs a lower unit. I have been searching around and the prices are out of this world. I have been told that this motor has the same lower unit as a yamaha. I'm just wanting to know what hp range for mariners and for yamaha, has the same lower unit. I saw a 4O hp...
  11. F

    15hp Evinrude, Any Ideas?

    My 15hp evinrude started acting up on me while i was out fishing two weeks ago. It would take off to top speed at full throttle and after about twenty seconds, it would die down. While it started to die down, if i left the throttle at full throttle, it would die completely, but if i cut the...
  12. F

    15hp Evinrude carb,DO YOU HAVE AN ANSWER?

    There is a small rubber piece with a smallhole in it at the bottom of the fuel bowl that is pressed into bowl. While cleaning the carb, i took this out to clean under it and it split on me. What is this called and will the motor still run properly without it? Thanks
  13. F

    9.9/15hp Evinrude running hot

    Hope someone can help/relate. I have a late 80's to early 90's 15hp Evinrude which i understand its the same as a 9.9 It just has a bigger carb. I also know that evinrude and johnson are pretty much the same. With this being said, the motor is running hot. I recently dropped the lower unit and...
Top