Search results

  1. Plandeck

    8hp starts but runs only at high rpms

    My 8hp 2007 Nissan outboard starts but runs only at high rpms. It dies when throttle is decreased. She ran fine the first day in the water, but after an hour of high rpm boating she would not idle without dying. Any suggestions?
  2. Plandeck

    Starter cranks intermittantly

    8hp Nissan outboard model NSF8A2 EF2 with key start sometimes cranks and sometimes clicks. Does this mean the starter is failing and should be replaced or rebuilt? Any other cures or trouble shoot ideas? Thanks!
  3. Plandeck

    8/9.8 hp Nissan peters out on low revs

    2007 8/9.8 hp Nissan outboard starts only with choke wide open and will run only at high revs. Close the choke and reduce revs and she dies off. Fuel filter, pump and carb are all working fine. Is this an ignition issue?
  4. Plandeck

    HP prop on 8hp Nissan less power

    I took some advice end of last season and replaced the 3 blade prop on my 2008 8hp Nissan outboard (converted to a thru hull sail drive on my 26' Grampian sailboat you may remember from other posts) with a 4 blade high performance prop....last week after bringing the boat down the river through...
  5. Plandeck

    Engin Basement Gasket leaking

    I've got oil leaking out around the engine basement gasket on my 2007 8hp Nissan outboard...so replacing the gasket do you recommend using a sealant in addition to the new gasket?
  6. Plandeck

    Gear Oil drains out milky blue

    I drained the gear oil from my 2008 8hp Nissan outboard and it came out milky blue...water in the gearcase? I don't observe any cracks in the housing...are there seals that typically need to be replaced?
  7. Plandeck

    Remote Control Cables all the same?

    I need to replace the remote control cable for the gear shift. The old cable kinked and snapped at the remote hand lever from repeated maintenance. Are all cables the same? A "high performance" Suzuki cable can cost $80 with shipping.
  8. Plandeck

    2008 4 Stroke Nissan High Speed Problem

    My 2008 4 stroke 8hp Nissan outboard runs fine for a while then starts choking for lack of fuel at high speeds. I've changed the fuel pump, filter and tried it with two different fuel tanks and hoses. Same result. Why would she start choking after warming up...still runs fine at lower speeds.
  9. Plandeck

    2008 4 Stroke 8 HP Nissan Leaking Oil

    My 2008 4 stroke 8hp Nissan outboard has started leaking oil after an all night ride this summer. She has never leaked before. I discovered it dripping down the back of the lower unit. its clean amber oil. Not dark and full of carbon deposits. Have I blown the head gasket?
  10. Plandeck

    recharging 2 battery system

    Anyone know where to attach an isolator relay switch between 2 batteries so both of them charge when my 8hp Nissan outboard is running? Sailboat has two batteries isolated from each other. One starts the motor. The other powers the boat lights etc. Thus only one battery charges up when motor...
  11. Plandeck

    8hp Nissan Choke Sticks

    Anybody have a good way of adding remote control to the choke on an 8hp Nissan OB? I added remote throttle and shift which work fine. But the choke still needed to be set manually. I jerry rigged a choke cable to it, but once open the choke sticks and often won't close without my doing it...
  12. Plandeck

    One outboard motor wired to two batteries

    The sailboat has two batteries that run through a master switch which can select either battery 1, battery 2 or both to connect with the lights, etc. Can the outboard motor be wired to both batteries at the same time so they both charge when the motor is running without destroying the master...
  13. Plandeck

    8hp Nissan OB misses in high revs

    My little 8hp Nissan outboard runs great except sometimes she misses in high revs. Engin is constant in low and medium revs but if I push the throttle she starts missing. Opening the choke helps this but should this be necessary? I've changed the fuel filter which seemed to work at first, but...
  14. Plandeck

    Remote control gear shift bolt comes loose

    The custom bolt fixing the remote gear shift lever to the engin body has twice unscrewed itself and come loose leaving me to operatye the shift lever manually to get home. This last time the bolt fell away and can not be found. Anybody have a solution for this?
  15. Plandeck

    Idle Exhaust Port Modification

    Anybody know why it would be wrong to exhaust idle gas from my 8h 2008 4 stroke Nissan outboard through the exhaust plug instead of the regular gas/water mix idle port? Too hot? The idle exhaust must run through 8' of 1/2-inch exhaust hose. (See attached drawing) Why this? I reinstalled the...
  16. Plandeck

    Nissan Outboard below deck

    I am planning to move the 8hp nissan outboard on my 26' sailboat from the rear transom to below the cockpit floor just behind the cabin stair. There is a place here for an inboard style motor that came as an option on the original boat but was never installed. Installing the outboard below...
Top