Search results

  1. D

    XR4 Bearing Carrier

    I would like to know how to get the carrier out. I have the crown ring off but I am not sure how to remove the carrier if anyone could help. I am trying to change all the seals.
  2. D

    200 Merc dies upon holeshot.

    I have a 90 V200 S#0c219197. I checked the timing, carb and thottle linkage, new plugs, comp test 115+ all 6, new primer bulb and fuel hose, new fuel filter. It has ran fine till about 2 trips ago. I ran out the old gas last week then filled up. It started right as the tanks were empty. When you...
  3. D

    over night power loss

    My 90 v200 (oc219197) just all the sudden won't idle or launch. I was tryin to run out older gas and ran the tanks out on Tues and she was fine. I gassed up went out Wed. And she wouldnt go. I changed the fuel filter and looked at the plugs but they look ok. Went out Sat. And got the same thing...
  4. D

    V200 Fuel Line Route

    Can anyone tell me were to find a copy of the fuel line route from pump throughout carbs for my Merc V200 powerhead. I dont have the seriel # to it because I just bought the powerhead not the whole motor and have mount it on my XR4 mid and lower. I want to make sure they are right. I think that...
  5. D

    V200 Loading up/stalling

    My V200 is acting as if it has too much fuel. Cleaned carbs and adjusted floats twice. After you take off the first time in the day it doesn't want to take off again and wants to die when you stop. If you get it going it runs fines. Any thoughts? I just bought it rebuilt last year and never have...
  6. D

    Powerhead Year/Jet Size

    I bought a rebuilt powerhead but am not sure what year it is. I thought he said 89 but I want to make sure. How can I do this. It is a V200 and it mounted right up to my 91 xr4 mid and lower.I would also like to know if I need to rejet the carbs. The powerhead came from PA. And I live in...
  7. D

    anti siphon valve

    Can someone tell me where the anti siphon valve is located? I have a 1990 200hp merc. Or is it in the tank?
  8. D

    fuel / unpriming system?

    I have a 90 Merc 200 it idles fine and the bulb pumps up but when you take off it stands up then wants to croak. If you pump the bulb it seems to help. Shouldnt the bulb stay hard all the time after pumping it? Once it gets up it runs but is down on speed. It acts like its flooding because if...
  9. D

    bog down at take off

    I have a 90) v200 merc S # oc219197. I just mounted it. When you first take off in the morning as long as you dont idle for a long ways it runs fine.Then once you run it or put load on it it wont take off. You can rev it real hard and then put it in gear and it usually takes off. Its worse with...
  10. D

    Merc v200 wont take off

    I post a thread lastnight but no one answered. Sorry bought the big letters! Cleaned carb, and check coil spark. Will start up run and rev but wont launch. It either bogs or dies. If you hit the enricher (chock) it will go but still not WOT RPM or speed. I'm gettin flustered! Big weekend here...
  11. D

    v200 help

    90 Merc V200 s#0c219197) Wont go anyplace! It will start and rev but when you put it in gear it dies! Cleaned carbs and checked coils. Coils are fine. If you tap the choke it takes off. But still not full RPM. Plus at idle its sputtering and you can hear a cyl puff. Ive been workin on this thing...
  12. D

    91Merc XR4 Fuel Bleeder lines

    Can anyone tell me or sent me a copy of the bleeder line routes for a 91 xr4 150. My son pulled them off when I was gone. I also need to know where the hose from the Carb silencer goes to.Thanks a bunch. docd32000@yahoo.com
Top