Search results

  1. S

    What Weedring do I need (or What Gearcase do I have)

    1995 E150ELEOM Want to try a weedring with the Renegade Bass prop. Which weedring do I need? or Which gearcase do I have M, L, M2....? Probably obvious, but I don;t know it. thanks Wxman
  2. S

    1995 150 Looper Voltage/Overvoltage Sanity Check

    1995 E150ELEOM. Late last season on one outing I noticed the volt gauge pegged over around 18. No other symptoms. I replaced regulator/rectifier and all seemed fine again until yesterday. On one run (short runs on this lake) I noted the volt gauge above 16 (seems to usually run close to 14...
  3. S

    Confused Recirculation Valves 1995 E150 Looper

    I am trying to check the accessible recirculation valves on the V6 looper. The manual only goes through the procedure for cyl 1. When at idle I get bubbles in the glass of water from the hose removed from the no 1 cyl block that is still attached to intake manifold. I can easily push alcohol...
  4. S

    1995 Evinrude 150 V6 Looper, One Last Issue

    I'll try to keep this short. Motor would just instantly die at speed. Would start back up and run fine. Took to two Evinrude mechanics. Ended up with 8 (yes eight) rebuilt carburetors and a new fuel primer bulb. Compression checked good. Each time upon return the boat never made it across...
  5. S

    1995 150 Looper Stalls When Given Throttle

    Hello to all, Try to make a long story short. Engine ran fine for years with basic maintenance. Started having issue where it would just cut out (stop), instantly, when underway. Very intermittent, but it was like someone pulled the emergency stop when it happened. First Evinrude certified...
  6. S

    Primer Bulb Orientation

    Hello all Does it matter how the primer bulb is mounted i.e vertically vs horizontally?? I know the fuel flow needs to follow the arrow, but since I don't know for sure how the check valve/ball works I wondered if it mattered whether the bulb was vertical or horizontal. I have always been in...
  7. S

    Powerpack 150 hp 60degree V6 OIS Ignition Evinrude

    Hello all, 1995 150hp V6. It is a 60 degree looper with OIS ignition. Can I change out the powerpack without destroying the ignition timing? Both manuals I have direct going through the sync and timing procedure after replacing, but they give no alternate method of timing without the OMC...
  8. S

    What Plugs??

    Over my years of ownership (and moving) I have visited 4 dealers regarding my Evinrude engine. Two have recommended QL78YC plugs and two have recommended QL77JC4 plugs. 1995 E150ELEOM. (60 degree V6 looper.) Owner's manual says 77. I have an original service manual that says 77. I have a...
  9. S

    E150 Dies, Immediately Restarts

    Looking for diagnostic help. 1995 E150ELEOM V6 w/ OIS Ignition System. Not a high hour engine. Starts easily, runs great. On a Fish and Ski boat. Can sometimes go out and run for 2-3 hours pulling the tube/skiing without issue. Most times out, however, I will have at least one instance of the...
Top