Search results

  1. C

    OMC 165HP in-line six won't run with new coil???

    I have a 1974 OMC electric shift with a 165HP in-line six. Engine has run well but while out trolling the other day engine stalled. A few minutes later I was able to start it, but then it died again about 15 min later and would not re-start. Got it home and put water hose to it and had...
  2. C

    OMC Electric shift Intermediate gear case Unidentifiable Threaded Objects "UTO's"

    OMC Electric shift Intermediate gear case Unidentifiable Threaded Objects "UTO's" I've got my OMC Electric Shift drive torn apart and am now getting ready to assemble it back together. I've never found an oil drain hole for the intermediate housing. Here are some pics of some threaded objects...
  3. C

    What type of adhesive/sealant to use on water pump shaft exhaust seal?

    I've got my electric shift outdrive torn apart and am now reassembling. My manual says to use 3M 1300 gasket adhesive on the spline shaft seal of the water pump shaft. Does anyone have a suggestion for a substitute? Can I just use some black silicone? Any advice appreciated!
  4. C

    OMC Electric shift upper gearcase pinion gear removal..?

    Okay, I got the pinion gear retaining nut off! I thought that was a miracle without the SST. I thought the whole shaft would then slide out with bearings, etc., because I need to replace the oil seals. I've posted some pics of the oil seal side, and you can see that the seals are popping out...
  5. C

    I'm going to paint my boat with Bedliner spray!

    Not really, but I was looking at some of the stick on keel guards cause that's what I need, but curiosity begs me to ask, what if I taped off the keel area and sprayed it with Bedliner? Yeah...I'm a noob
  6. C

    I'm going to paint my boat with Bedliner spray!

    Not really, but I was looking at some of the stick on keel guards cause that's what I need, but curiosity begs me to ask, what if I taped off the keel area and sprayed it with Bedliner? Yeah...I'm a noob
  7. C

    Stringer impeller replacement, use old key or replace?

    I've removed the water pump housing and have a new replacement kit. Manual says to replace impeller key with a new one. Kit did not include a new one. Can I use the old one? Also, manual says to disassemble swival housing for water pickup inspection, is this necassary? Lower unit seems to be...
  8. C

    Stringer ball gear replacement help

    I've started to replace my ball gears. Had to take the upper assembly to my mechanic for help removing the badly corroded tetaining nut, biggest impact wrench and heat got it off (thankfully). After reading in the manual that the driveshaft in the intermediate housing may require removal of the...
Top