Search results

  1. A

    PL-88 load adapter

    I have a 1995 Johnson 200hp Venom with no spark on all cylinders, the stator is new, the timer base dva output is .5 -.8 volts. To check power pack output my Seloc manual says to disconnect the primary lead to the coil and use a load adapter to check the voltage. Does leaving the primary lead...
  2. A

    Timer base resistance readings

    I have a 1995 Johnson 200hp. Venom. I've been checking the resistance on the connectors of my timer base following the instructions in my Seloc repair manuals (I have two of them), the best I can get is about 740 ohms from the white to the colored pins, from port side white to starboard side...
  3. A

    Test wheel needed

    I'm still looking for a test wheel for my 1995 Johnson 200hp. I can't even find a part number reference. Any help is appreciated.
  4. A

    50hp mercury hard to start even when warm

    I have a 2003 50Hp Mercury that is hard to start even after it's warmed up, it won't start by just turning the key, I usually have to move the throttle to about 1/4 to 1/2 throttle just like it's the first cold start of the day.
  5. A

    Testing 200hp Johnson stator

    I'm suspecting the stator is bad, when the battery is connected the battery will drain very quickly and when I felt up under the flywheel the stator was burning hot to the touch, I have the stator off the motor and need to know how to check it. It's a 1995 Johnson Venom 200 hp. Thanks
  6. A

    thru hull transducer

    I'm going to mount a humminbird 153 Piranha fish finder on my pontoon boat, will the transducer work thru the aluminum mounting bracket on the back of the pontoon? i was going to epoxy it to the bracket to keep it more protected than being mounted underneath it. Thanks
  7. A

    Engine stalling after running then sitting for a while

    I have a 1995 Johnson 200HP venom outboard, and the problem is that after I have it running for a while then stop and sit for a while and want to go again the motor starts up fine but will repeatedly stall out, it fires right back up and runs for anywhere from a few seconds to a couple of...
  8. A

    tachometer problem

    I have a 1995 Johnson 200 HP Venom outboard, I'm having a problem with the tachometer, it stopped working, I checked the wiring and there is a connector about a foot from the tach that when i disconnect it I get 12 volts coming from the wiring from the motor but when i plug it in I get only...
Top