Search results

  1. C

    98 Evinrude 115 (E115SLECM) Not going into gear

    The boat has been setting for the last 2 years on the lift. Got it prepped to put back on the trailer, backed it out off the lift and went to put in forward gear and it's like it's in neutral
  2. C

    2015 Yamaha 150's Over Temp Alarm (both engines)

    Little background, both engines have less than 120 hrs on them now. I had the 100 hr service done @ 100 hrs, I do flush the motors after every use. Took the boat to the key's for a week and the 1st day out on the way in I get an over temp alarm on Engine 2, so I immediately shut down both...
  3. C

    98 Evinrude E115SLECM Eventual Bog @ 5000 RPM

    I really had not used the boat for some time, still getting things sorted from Irma.. After Irma I replaced all the lines to the oil tank + new ball, screen, gaskets, new impeller, fuel filters & changed lower gear oil + decarb. Plugs looked OK, might have 75 hrs on them since last set...
  4. C

    1998 115 (E115SLECM) Tilt Motor Change

    My tilt motor actually still works but its really rusted bad. Since I've got the boat on the trailer to do the WP thought i'd do the tilt motor before it goes. I didn't want to pull the motor if I can help it. Was hoping i could get to those rear screw by getting the top pin out of the trim...
  5. C

    98 115 Ocean Pro (E115SLECM) is it running hotter than it should?

    When I got this motor it didn't run, thanks to many on hear my family has been enjoying this rig. I replaced the water pump when I initially got the motor, based on the temp guage at idle speed (no wake) it would creep up to just about the 175 (80 celsius) on the gauge and then drop down to...
  6. C

    2015 Twin 150's - connecting to Garmin

    Want to display engine data on the Garmin but unsure on what all I need. There is a bus that has (3) connections for Devices + (2) bus connections. One has a terminator and the other has a connection into the bus (guessing that's power???) I know I'd need a NMEA2000 starter kit to extend the...
  7. C

    Yamaha 150's? (2015) Few questions.

    I'm about to take delivery of a new (to me) boat that has new 150's on it. After I've been looking now I see there has been issues with past 150's with the harmonic balancers.. I had seen that some said newer models they moved away from the nylon gears, that true? Also I notices some...
  8. C

    98 115 (E115SLECM) one bank of plugs rusting?

    Motor is running fine, no sign of issues other that when I pulled the cowling to get the model # off the plugs (just getting ready for planned tune up) I noticed one bank the outside of the plugs are very rusty.. other side is NO rust? Ran it last weekend, temp fine.. runs great.. Can't be...
  9. C

    98 115 (E115SLECM) Part# for tell-tail plug

    Was only a matter of time, I knew this would happen.. Got the boat on the lift, was done flushing the motor and went to put the tell-tail plug back in and dropped the damn thing.. It bounced around and sure enough ended up in the canal. Was trying to find a part# to replace but don?t see it...
  10. C

    98 115 (E115SLECM) questions on WOT timing procedure

    Wanting to check my WOT timing and was reading the Joe Reeves timing procedure and have questions, looking for advice. http://forums.iboats.com/engine-frequently-asked-questions-faq/joe-reeves-wot-timing-procedure-228183.html 98 115 (E115SLECM) looper 1) I understand I need to disconnect the...
  11. C

    98 115 (E115SLECM) Fuel Delivery Issues (driving me crazy)

    1998 115 (E115SLECM) that bought the boat about 3 moths ago. The boat had sat for years. I?ve drained the tank, replaced all the fuel lines from tank to engine, new primer bulb, plugs, + I?ve rebuilt the carb?s and replaced the inline filter and added new 10 micron filter. Even after this I...
  12. C

    1998 115 Evinrude Won't Start

    I have a 1998 115 (E115SLECM) that I just bought, it's been sitting for the last 4 years. I pulled and went through the 4 throttle bodies they were pretty clean but none of the floats were adjusted the same. I did new needles, seats, floats, etc.. Also did water pump and lower gear oil, plugs...
Top